0
You should use unleaded fuel in a Mercury 115 boat engine. Most modern outboard engines, including Mercury models, are designed to run on unleaded gasoline to prevent engine damage and ensure optimal performance. Always check the owner's manual for specific fuel recommendations for your particular engine model.
What else can I help you with?
Where can I find parts for an old mercury out board engine?
A boat shop
What is the gas ratio for a mercury 7.5 hp boat engine?
50:1 i belive
What octane gas should you use in 1996 mercury boat motor?
For a 1996 Mercury boat motor, it's generally recommended to use regular unleaded gasoline with an octane rating of 87. However, if the engine is high-performance or shows signs of knocking, you may consider using mid-grade fuel with an octane rating of 89. Always consult the owner's manual for specific recommendations tailored to your motor model.
How late did GM continue to produce the 305 engine?
2003 for highway applications. It's still in production as a boat engine for Mercury Marine.
Where is the oil filter located on a 1996 mercury boat?
If it is a 2 cycle engine, it has no oil filter. If it is a 4 cycle engine, the filter is located under the engine cover.
What is the best bass boat engine?
Mercury outboards are best. Johnson Sea Striker series is good too.
Were do you hook a chain to remove mercury 150 outboard boat motor?
Mercury Marine uses a lifting eye that threads into the flywheel hub for mounting, and removing, the engine.
How do you fill with fluid mercury trim motor?
To fill your Mercury Outboard Trim boat motor, lower your engine to a 45 degree angle, Make sure your boat is level. Remove fill screw, and add the amount of fluid required to fill.
Mercury boat motor 150hp schematic?
how to take cover off 1979 mercury boat motor
Who leaded the Spanish armada?
Well, Duke Media Sidona was the Spanish General on the boat but he had never been on a boat, and was therefore seasick a lot of the time
Where are freeze plugs on a mercury 350 v8 boat engine?
Freeze plugs, also known as core plugs or expansion plugs, on a Mercury 350 V8 boat engine are typically located on the sides of the engine block. They can also be found on the cylinder heads, depending on the specific engine design. Their primary function is to protect the engine from damage due to freezing by allowing coolant to escape if it expands when frozen. To locate them, check the sides of the engine block and the rear of the cylinder heads for small, circular metal plugs.
Is a 2006 mercury 225 hp outboard made by Yamaha?
Yes. I have a friend who is a Yamaha dealer and I bought a boat from him with this engine and he had his regonal distributor run the numbers to be sure this engine was made by Yamaha.
