0
i did it w/o help, until it was ready to move onto the bow. Put 2x4's in position like rails from the cabin roof to the bow. Slide the bridge off and onto the rails, to the bow. Tie off the bridge before you move it and pay out line to control it. Used thick carpet to cushion the bridge when on the bow.
Take pictures of the wires under the bridge, so you can put them back. Have wire in same colors on hand for replacement. Cut ties which hold harnessed wires, then pull harness apart. Cut other wires toward middle of length and use connectors crimped onto them for future assembly.
Remove Power Steering lines and cap off to stop hydrolic fluid leaks.
Remove screws which hold bridge in place on cabin deck. Be prepared to use calk into screw holes so fresh water rain doesn't get in.
Remove seats and stanchions and rails from bridge to reduce height below max limit.
You can use machinery like a lift, to assist you.
Talk to the workers at your marina for ideas. Try you tube video help.
What else can I help you with?
Can you remove a fixed bridge?
Yes it is possible to remove a fixed bridge there is no problem.
How do you replace the alternator on a 1998 Buick LeSabre?
Disconnect the 98 LeSabre battery. Remove the alternator belt. Remove the alternator wiring. unbolt the alternator, remove it, and bolt the new one on. Reconnect the wiring, but the belt on, then reconnect the battery.
How do you get the oil change required light to go out on a 2006 crown Victoria after changing the oil and filter?
There are two ways to do this. First remove the battery terminals then reconnect them. The second option is to remove the fuse and then reconnect it.
How do you replace the alternator on a 1990 Buick Regal?
Disconnect the 1990 Regal battery. Remove the alternator belt. Unhook the wiring from the alternator then unbolt it. Remove and replace the alternator then reconnect the wiring, belt, and reconnect the battery to finish the installation.
Can you remove crankshaft bridge from motor and still function?
NO
How do you remove a starter from Hyundai sonata?
Look to the front left of the engine where the transmission mounts to it, you will see the starter there and it has several large wires bolted to it. Remove those wires ( after you have disconnected the battery ) and then remove the two bolts holding the starter on, replace with the new one and reconnect the wires, then reconnect the battery and off you go.
How do you reset code p1320 on 2000 Maxima?
remove ground terminal on battery for 5 minutes and reconnect
How do you change spark plugs on a 1996 Toyota Camry LE 4-cylinder?
Disconnect the battery, remove the spark plug cables and covers, and remove the old spark plugs. Next, put in the new spark plugs, reconnect the spark plug cables and covers, and reconnect the battery.
How to Lower action on guitar?
If the bridge has an adjustment then use that. If not it is more difficult and depends on the desin of the bridge- it may be possible to remove the saddle (strip that strings press on) and reduce its size - can be tricky. If you over reduce there is a danger of getting string buzz on some frets which may need CAREFULLY sanding down if they are too high.
How can I install a guitar bridge?
To install a guitar bridge, first remove the old bridge by loosening the strings and unscrewing it. Then, place the new bridge in the correct position and secure it with screws. Finally, restring the guitar and adjust the bridge for proper intonation and action.
How do you replace an alternator on a 1991 buick regal?
Disconnect the 1991 Regal battery. Remove the alternator belt and wiring. Unbolt the alternator and install the new one. Reconnect the wires, install the belt, then reconnect the battery.
Are steel fence posts difficult to remove?
Yes, steel fence posts are difficult to remove. This is especially true if they are set in concrete. It may be necessary to rent a farm jack from a tool to remove them.
