water receives heat to become vapour thus carrying energy .
water is mainly used because it is plentiful and has very high latent heat of vapourisation which absorbs a hell lot of heat during evaporation.
here heat energy is converted into pressure energy during heating formation of steam and then expanded in turbines or let out to get kinetic energy as the output.
whenever steam is utilised as heating media, steam condensate is produced.This steam condensatecan be utilsed for steam generation at some other location and needs to be pumped, for pumping you need some intermediate storage of this condensate. For storing it we use condensate pot whose level can be controlled.
Condensate yield refers to the amount of liquid (condensate) produced from natural gas or oil during processing and separation. It is commonly expressed as the volume or percentage of condensate recovered from the raw natural gas or oil. Achieving a high condensate yield is important for maximizing the value of the produced hydrocarbons.
Condensate is primarily used as a noun. If it's being used as a verb the past tense is condensated.
Yes, AC condensate is typically slightly acidic due to the presence of dissolved carbon dioxide in the water.
A condensate is a liquid that is formed from the process of condensation. An example of a condensate is the water that forms on the outside of a glass filled with water and ice on a very hot day.
An inverted steam trap works by allowing condensate to flow out of the system while preventing steam from escaping. When condensate builds up, the trap closes and prevents steam from passing through until the condensate is released. This helps maintain efficient operation by removing unwanted condensate and maintaining steam within the system.
A device that will allow cooler condensate to pass and hold back the higher temperature steam
It works on the principle that condensate at a given temperature will flash to steam after pressure has been significantly reduced.
A steam trap is used to remove condensate (liquid) that forms in steam systems. If condensate is not removed, it can cause water hammer, reduce heat transfer efficiency, and affect the overall performance of the system. The steam trap helps prevent damage to equipment and ensures that only steam flows through the system.
Discharge condensate as soon as it is formed.Have a negligible steam consumption.Have the capability of discharging air and other non-condensable gases.those are the three important functions of a steam trap
To calculate the conversion of steam to condensate, you can use the formula: Steam Converted to Condensate = Steam Inlet - Steam Outlet This formula subtracts the amount of steam leaving the system (Steam Outlet) from the amount of steam entering the system (Steam Inlet) to determine the amount of steam that has been converted to condensate.
whenever steam is utilised as heating media, steam condensate is produced.This steam condensatecan be utilsed for steam generation at some other location and needs to be pumped, for pumping you need some intermediate storage of this condensate. For storing it we use condensate pot whose level can be controlled.
condensate,bleed line of all condensate
The purpose of a furnace condensate trap is to collect and remove water that forms during the heating process. This helps prevent water from entering the furnace and causing damage. The condensate trap contributes to the efficient operation of a heating system by ensuring that the furnace functions properly and efficiently without being affected by excess moisture.
Condensate is what you get when you condense steam (water) that was heated in a boiler to make the steam. I'm not sure what else you are looking for.
Steam is produced in Boilers of suitable design depending upon the requirement. Due to heat loss in the system due to various reasons steam is likely to lose the heat and slowly condense in to water. Some Equipments using the steam are not suitable to accept steam with water contents. Hence we have to prevent the condensate ( water) from entering such system/equipments. To do this we use a product called Steam Trap. Steam traps are designed for retaining the steam alone ( as clear from the name) and allow only the water to exit the system through suitable drain piping. This safeguards the system/equipments using the steam ...
whenever steam is utilised as heating media, steam condensate is produced.This steam condensatecan be utilsed for steam generation at some other location and needs to be pumped, for pumping you need some intermediate storage of this condensate. For storing it we use condensate pot whose level can be controlled.