answersLogoWhite

0

What else can I help you with?

Related Questions

How does an inverted steam trap work?

An inverted steam trap works by allowing condensate to flow out of the system while preventing steam from escaping. When condensate builds up, the trap closes and prevents steam from passing through until the condensate is released. This helps maintain efficient operation by removing unwanted condensate and maintaining steam within the system.


How does a impulse steam trap work?

It works on the principle that condensate at a given temperature will flash to steam after pressure has been significantly reduced.


What is the purpose of a condensate drain trap in an HVAC system?

The purpose of a condensate drain trap in an HVAC system is to prevent air from escaping or entering the system while allowing water to drain out.


What is the proper way to run a condensate drain with a trap Does it need a vent?

The condensate drain on the a-coil should have a trap and the trap should be vented for proper operation . The vent should rise above the top edge of the drain pan in the unit. Their should be a capped clean out before the vent.


What is the purpose of an HVAC condensate trap and how does it contribute to the overall efficiency of the system?

An HVAC condensate trap is used to prevent water from accumulating and blocking the system. It helps maintain proper drainage, preventing clogs and ensuring the system runs efficiently.


What is the purpose of a furnace condensate trap and how does it contribute to the efficient operation of a heating system?

The purpose of a furnace condensate trap is to collect and remove water that forms during the heating process. This helps prevent water from entering the furnace and causing damage. The condensate trap contributes to the efficient operation of a heating system by ensuring that the furnace functions properly and efficiently without being affected by excess moisture.


How do you install condensate p-trap?

The same as any other P trap except it should empty into a properly trapped and vented fixture


What is a steam trap?

A device that will allow cooler condensate to pass and hold back the higher temperature steam


Does a steam trap remove condensate?

water receives heat to become vapour thus carrying energy . water is mainly used because it is plentiful and has very high latent heat of vapourisation which absorbs a hell lot of heat during evaporation. here heat energy is converted into pressure energy during heating formation of steam and then expanded in turbines or let out to get kinetic energy as the output.


Why do you need to have esp to calculate the u trap size for condensate drain in ahu?

Because the weight of the water in the trap must be greater than the esp or the trap will be ineffective,and the trap size dictates how much water it can hold thus determining the weight.


What is the purpose of the HVAC condensate drain trap and how does it contribute to the overall efficiency of the system?

The purpose of the HVAC condensate drain trap is to prevent air from escaping the system while allowing water to drain out. This helps maintain proper airflow and prevents energy loss, contributing to the overall efficiency of the HVAC system.


Dose a positive pressure drain need a trap?

A trap on a positive drain is used to avoid the 'contaminated' air in a HVAC system from traveling through the condensate line and entering into areas where it is unwanted. The trap becomes necessary when one condensate line is used for multiple units, especially if it is tied to other negative pressure drain traps. The negative pressure drain traps may not drain properly if they have to overcome the positive non- trapped pressure of another unit. It allows the condensate to drain more evenly, as well. Without a trap, the positive pressure from the unit can blow air through the drain with the water and cause 'spitting.' A trap on a positive pressure system may not always be necessary, but it is good practice to trap every drain and trap it properly. There are guidelines for both positive and negative pressure traps. Always follow the manufacturers recommendations.