0
What is the pressure inside a ronson butane refill can used to refill cigarette lighter can someone tell the actual p.s.i.?
Wiki User
∙ 12y ago
usually about 45 psi
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the actual density of 100 ml of water?
At standard pressure and temperature the density = 1.0.
What is the ratio of colour cream dye to developer cream and is the higher the vol the lighter it will lift?
No. Different companies use different ratios in their products. It is the actual type of colour you are going to use that will depend on the lift eg. semi, quasi or permanent.
What is the actual density of sulfur?
The actual density of sulfur is 300 kg
Describe the subatomic particles in an atom?
Subatomic particles are particles that are smaller than the actual particle. which means that the actual atoms had a sub-atom,which is apart of the actual atom
Can a reaction ever have 110 actual yield?
No, a reaction can never have an actual yield of 110. If an actual yield of 110% if obtained, then the product must contain impurities which increase the experimental mass.
How many amps does the actual cigarette lighter PLUG in the car draw?
25
How do you replace a cigarette lighter in a 1999 Chrysler Sebring?
If you just mean the actual lighter part itself( the part that pops out when hot),almost any vehicle lighter would work.
Which fuse in the two fuse panels is the cigarette lighter fuse for the 1997 4-runner someone claim that the acc fuse number 18 is the one but all of the other systems that fuse protects still works.?
I just read on here somewhere else that if the radio is still working the problem may be a small brown wire on the back of your actual cigarette lighter that needs to be redone. good luck
Do all Peugeot 206's have a cigarette lighter?
I would suggest that as you are asking this question, you have a cigarette lighter-less 206 or have seen a few around. The simple answer is no, not all 206's have cigarette lighters. They do have a plug behing the blanking plate that a peugeot cigarette lighter will plug into, or you can easily (and cheaply) fit a universal aftermarket one with a hole saw and some crimp connectors. Some are also supplied with the socket but not the actual insertable plug (the bit that gets hot) in which case you can get one from most reputable breakers yards.
How do you put the cigarette lighter on a 1997 Dodge Neon back together?
Most cigarette lighter assemblys are in two parts, first you would insert into dash, and from the back side screw on the back from under the dash. are we talking about the actual lighter that has the heat element, or are we talking about the socket adapter. I have posted for socket, if this is just the lighter itself, these usually screw together also, most of the time it is just easier to replace the lighter at your local auto parts store, or go to your local salvage yard.
Where is the fuse for the cigarette lighter on a 1994 Nissan Sentra?
If you have checked the main fuse panel and did not locate it (could be linked in with an accessory fuse) the other place to look is behind the actual lighter casing itself, the silver "socket" that the lighter fits into can be pulled out and it will be attached to a wire with a fuse inline. Good Luck!
Lighter works but horn doesnt Chevy cavalier 96?
The cigarette lighter (I'm assuming that's what you meant) is on a separate fuse than the horn. Check that fuse, if the fuse is fine then your most likely culpret is the actual horn switch in the steering wheel.
Where is the fuse for the cigarette lighter in a 1997 Acura TL 3.2?
there are two, one in the fusebox on the right kick panel, near the drivers feet, and one is on the back of the actual cigarette lighter socket its self, its a small rubber thing with two wires coming out of it, if blown, it will be slightly swollen... i just replaced mine with a wire, as it already has a fuse at the drivers feet, to the right
How do you replace a cigarette lighter for a 2000 Honda Civic?
First of all, be sure to check for a blown fuse. Then, you will have to pull the ashtray and expose the lighter charging coil, which is the round metal piece that the actual lighter rests in. Disconnect your battery, and then disconnect the wiring harness clip from the back of your lighter, then you twist the lighter counterclockwise to unseat it for removal. Installation is the reversal of these steps.
How do you remove the cigarette lighter in a 97 Chrysler Sebring convertible?
In mine I just removed the actual lighter and set it aside. Then, reach your hand behind the whole thing where the wires connect and disconnect them. There should be 2 of them connected to the lighter and they should both just pull off (there is also a third wire for a light under there- leave that one there). The amp wire was a bit harder to disconnect but it just pulls straight off so don't worry about breaking it. Once the wires are disconnected hold the back of the lighter steady while you use a finger to apply pressure inside the lighter and turn to the left. It should just unscrew and you'll have a piece of it in each hand. Hope I explained it ok. Good luck.
What causes the cigarette lighter in a car to be able to light cigarettes but not supply voltage to accessories?
The actual lighter is just a coil of metal that is specifically designed to provide enough resistance to electricity that when it is passed through it heats up, similar to the design of an incandescent light bulb. It's not storing electricity it's just resisting it enough to cause it to heat up.
How do you install a cigarette lighter on a 1987 Oldsmobile Calais?
The most I can tell you is that if you have the actual cigarette lighter setup in there, but it doesn't work, then who you bought it from probably disconnected the wires like my dealer did. He said it was because it was shorting out or something, but I hooked it back up and never had a problem yet, so... If it is how I expect, then you can just pull out the casing for the cig. lighter and reach in with a pliers and start grabbing until you get it...Or you could take off the entire center panel to get to it which is a pain unless you've done it before. Can't help ya with installing a complete brand new one if that is what you were looking for though, sorry.
