answersLogoWhite

0

i would place the inlet closer to the bottom and the output closer to the top on the opposite side of the aquarium

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Is there a right and wrong way to install a fuel filter?

Yes, there is an Inlet and Outlet. From the fuel tank, the fuel enters the inlet side and exits from the outlet side. The filter should be marked or possibly have different size connectors.


What direction does the fuel filter go?

Depending on the fuel filter, it will either have an arrow or be label inlet and outlet. The arrow should be placed pointing away from the tank. Those labeled inlet and outlet will only attach in the correct direction.


Where do you attach the hose to the filter?

To attach the hose to a filter, locate the inlet and outlet ports on the filter unit. The inlet port is usually where water enters the filter, while the outlet port is where filtered water exits. Securely connect one end of the hose to the inlet port and the other end to the water source, then repeat for the outlet port to direct the filtered water to its destination. Ensure all connections are tight to prevent leaks.


Hook up and return lines for a doughboy silica II filter?

The connection on top is from the filter inlet (discharge of the pump). The connection on the opposite side of this one is the filter outlet back to the pool. The connection below the filter inlet is for backwashing the filter.


On a fuel filter the out intlet goes to the motor?

Yes. Inlet is from the fuel tank, outlet is going to the engine.


Which is Fuel pump inlet and outlet?

Inlet line will be bigger then the outlet line. on the contrary on my motorcycle fuel pump, the inlet and outlet are the same size!


How do you use a quick disconnect tool for fuel lines?

position/clamp the tool over the inlet flow tubing. hold tightly and push in towards the fuel filter to unlock the plastic clip of the pressure hose. pull the outlet clamp/lock up off and out of the way on the outlet side. perfom same procedure as the inlet side to disconnect it.


What fuel hoses go to which arrows on filter?

The arrows should point toward the front of the vehicle. Example. Front of vehicle <<< outlet (fuel filter) inlet <<< fuel tank


Should there be a rubber o-ring on the inlet and outlet fuel lines connected to the fuel filter on a 1999 Chevy silverado 5.3L?

NO, they are flared


How to setup Hose placement on a sand filter?

To set up hose placement on a sand filter, first, ensure the filter is connected to the pool's plumbing system. Attach the inlet hose from the pool pump to the filter's inlet port, which is typically located at the top. Next, connect the outlet hose from the filter's outlet port to the return line that leads back to the pool. Finally, ensure all connections are secure and check for any leaks before starting the system.


What is the inlet and outlet valve clearances on a 1975 Ford cortina 1600?

valve clearance hot - inlet mm 0,3 and outlet 0,56


Where is the low and hi side on a ac compressor?

The inlet side is the low side - this will have the larger hose. On a Thermal Expansion Valve system, this hose will run from the evaporator outlet to the compressor inlet. On a Fixed Orifice Tube system, this hose will run from the accumulator outlet to the compressor inlet. The outlet side is the high side, and the hose will run from the compressor outlet to the condenser inlet.