answersLogoWhite

0

The ECM (Engine Control Module) or PCM (Powertrain Control Module) may appear to look the same as others but most are programmed (Flashed) to exactly match the vehicle it is going in.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

What is cylinder head torque for ford bantam 1300 rocam engine?

This will vary in the vehicle that is being used. Some of them will use more power than the others.


What is the torque settings for mains and big end bearing on Ford Bantam 1.3i 2003?

The year, make and engine info would help.


Where is a Ford bantam's thermostat situated?

the following is on a ford bantam 2006 Rocam: if you open the hood and stand in front of the engine, look at the the side on the right of the engine, you can see the hoses from your radiator meeting up and connecting to a black plastic fitting , that is your thermostat housing, be careful they break easily if you try and remove them. the thermostat is inside the housing, hope this helps.


What are the torque settings for cylinder head bolts on Ford Bantam 1.6 2004?

Ford 1.6 Rocam Motor: 10 bolts x 40NM + 120 degrees 2 bolts x 15NM + 45 degrees


What is the torque settings on ford bantam 1.3 rocam cylinder head?

There are three progressive tightening steps when setting the torque on the cylinder head bolts on the 1987 - 1994 Ford Bantam 1.3 Rocam . The first step is 50 - 55 ft. lbs. (68 - 75 Nm). The second step is 60 - 65 ft. lbs. (81 - 88 Nm). The third and final step is 70 - 85 ft. lbs. (95 - 115 Nm)


What is the torque settings on ford bantam 1.3 rocam cylinder head bolts on the 2004 model?

For the 2004 Ford Bantam 1.3 Rocam, the cylinder head bolts typically require a torque setting of 20 Nm (14.8 lb-ft) for the initial stage, followed by an additional 90 degrees for the final stage. It's essential to follow the manufacturer's specifications carefully and to ensure the bolts are tightened in the correct sequence to prevent warping or damage. Always consult the service manual for the most accurate and detailed procedure.


What is the fuel consumption rate of Ford Bantam 1600 1989 model CVH engine?

6km


Where is the heater control valve in a ford bantam?

It is located behind the bulkhead, accessible from the engine bay.


What to do my ford bantam 1.6Rocam it wont start the computerbox is new it has no spark i?

If your Ford Bantam 1.6 Rocam won't start and you're not getting a spark despite having a new computer box, check the ignition system first. Inspect the ignition coil, spark plugs, and wiring for any damage or loose connections. Additionally, confirm that the crankshaft position sensor and camshaft position sensor are functioning properly, as they are crucial for spark generation. If these components are all in good condition, consider checking the immobilizer system and related fuses.


How do you find temp sensor on ford rocam engine?

Facing the engine its on the right hand side of the engine just under the second hose to the air filter it clips in usually a light grey colour


Electrical diagram for ford bantam 1600 1997?

electrical problem,ford bantam 1600 1997


Ford bantam 1.3i cambelt?

Ford bantam 1.3 Xl 2004 timing chain or cambel?