Dipstick on the front, low to the ground, between the front wheels. Raise the mast and you will see it. The same fluid lubricates the front axle. Mine takes 15 quarts.
clark forklift gl35
To check the transmission fluid on a forklift, first ensure the forklift is on a level surface and the engine is off. Locate the transmission dipstick, usually found near the transmission assembly, and remove it. Wipe it clean, reinsert it fully, and then remove it again to check the fluid level; it should be within the designated range on the dipstick. If low, add the appropriate transmission fluid as specified in the forklift's manual.
vtyjhgbnlikgfudrtyfghnlk,gjvctrfghfgbhn
type of transmission fluid a 1994 nissian forklift uses
The type of transmission fluid used in Clark forklifts typically depends on the specific model. However, many Clark forklifts use automatic transmission fluid (ATF), often specified as Dexron or Mercon. It's important to consult the operator's manual for your specific model to ensure you use the correct fluid type and avoid any potential damage. Always check the manufacturer's recommendations for the most accurate information.
80 weight transmission fluid is recommended for the Toyota forklift. The transmission fluid is actually hydraulic fluid. The transmission fluid should be changed every 250 hours.
Honey, you're gonna want to use a transmission fluid that meets the Komatsu specifications for your forklift. Check the owner's manual or contact a Komatsu dealer to get the right fluid for that bad boy. Don't go pouring just any old stuff in there, unless you want your forklift to throw a hissy fit.
Dextron 2 8.1Liters - Automatic
AW-32
80W90
cause its broke
You may have a broken transmission or be low on transmission fluid.