answersLogoWhite

0

THERE IS A RELAY ON THE SHUT OFF AND SOMETIMES IT DOES NOT RESET AFTER THE KEY IS SHUT OFF .ORIGINALLY WHEN YOU TURNED YOUR TRACTOR OFF AND ENGINE STOPPED YOU WOULD HEAR A CLICK.THIS WAS THE SHUT OFF RELAY RESETTING

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

If Leaking hydraulic fluid from drive shaft at transfer case on Kubota l2900 tractor what to check?

Take the soft cover off, the drive shaft out and put the seal back in. Then install the fix kit from kubota. Its a common problem.


How do you turn on glow plugs on Kubota L2900?

To turn on the glow plugs on a Kubota L2900, first ensure the tractor is in neutral and the ignition key is in the "ON" position. Then, locate the glow plug switch, which is usually a push button or a toggle switch on the dashboard. Press or toggle the switch and hold it for a few seconds until the indicator light (if equipped) turns off, indicating that the glow plugs are activated. After this, start the engine as usual.


Where do you check the hydraulic oil for Kubota L2900?

To check the hydraulic oil on a Kubota L2900, locate the hydraulic oil dipstick, which is typically found near the rear of the tractor on the hydraulic reservoir. Remove the dipstick, wipe it clean, reinsert it, and then pull it out again to check the oil level. Ensure that the oil is within the recommended range marked on the dipstick. Always check the oil level when the tractor is on a level surface and the engine is off.


How do you change bearings on fromt wheel Kubota l2900 2x4?

To change the front wheel bearings on a Kubota L2900 2x4, first, lift the front of the tractor and securely support it. Remove the front wheel by loosening the lug nuts and taking the wheel off. Then, take out the hub assembly by removing the retaining bolts and gently pulling the hub off the spindle. Replace the old bearings with new ones, reassemble the hub, and reinstall the wheel, ensuring everything is properly torqued to specifications.


How do you check hydraulic fluid level on a 1998 Kubota L2900?

To check the hydraulic fluid level on a 1998 Kubota L2900, first ensure the tractor is on a level surface and the engine is off. Locate the hydraulic fluid reservoir, typically found near the rear of the tractor, and remove the filler cap or dipstick. Wipe the dipstick clean, reinsert it without screwing it in, and then remove it again to check the fluid level against the marked indicators. If the level is low, add the appropriate hydraulic fluid until it reaches the recommended level.


Headlights wont shut off?

check the headlight/multifunction switch


1998 ford escort ac compressor won't shut off on all settings?

why wont the ac compressor shut off stays on on all settings


What does it mean when you shut off your car and it acts like it wont shut off?

That's called dieseling, and the main thing that causes it is improper ignition timing.


Your brake light wont shut off in your 1997 Pontiac Bonneville?

is your e-brake on?


Why wont clock display shut off in blazer?

It is designed to stay on. It will not drain your battery.


1992 dodge shadow just shut off wont start changed wires plugs dis cap and rotor?

Car just shut off checked getting fuel cranks good just wont turn over


Theft system is on and wont shut off of your 98 sunfire?

does any one know how o shut off the theft system so i can drive my car it will start then die