0
What else can I help you with?
What would cause a wheel stud to break on 1992 dodge spirit?
Over torqued, under torqued, age, abuse.
Torque for 1999 dodge 3.3 liter cylinder head?
The 1999 Dodge 3.3 liter cylinder head bolts should be torqued at 160 pounds psi. The head bolts should be torqued in 40 pound intervals.
What causes valve covers on dodge intrepid to crack?
The bolts that hold it on are over torqued.
What are the torque specifications for the water pump bolts on a 1992 Dodge Dakota?
For all 1992 Dodge Dakota V6 andV8 engines:All of the water pump bolts are to be torqued to 30 ft. lbs.For 1992 Dodge Dakota 4 cylinder engines:Upper bolts are torqued to 21 ft. lbs.Lower bolts are torqued to 40 ft. lbs.Waterpump housing-to-cover bolts are torqued to 105 inchlbs.
Why would a axle nut loosen on a 2008 dodge grand caravan?
It might not have been torqued properly.
What are the torque specifications on a transmission valve body?
It depends on the transmission. A Dodge 46RE for example is torqued to 100 inch lbs.
How do you install a wheel bearing on a Dodge Magnum?
To install a wheel bearing on a Dodge Magnum, first, lift the vehicle and remove the wheel. Next, take off the brake caliper and rotor to access the hub assembly. Remove the hub assembly by unbolting it from the knuckle, then press the new wheel bearing into the hub. Finally, reassemble the components in reverse order, ensuring all bolts are torqued to the manufacturer's specifications.
How do you change wheel bearings on a 92 dodge cummins?
To change the wheel bearings on a 1992 Dodge Cummins, first lift the vehicle and remove the wheel. Next, remove the brake caliper and rotor to access the hub assembly. After that, remove the hub assembly from the spindle, which may involve taking off the retaining nut and any clips. Replace the old bearings with new ones, reassemble the hub, and ensure everything is torqued to the manufacturer's specifications before reinstalling the wheel.
After 20000 miles since spark plugs installed and engine serviced what causes a spark plug to blow in a Dodge Caravan 2000 Stripping engine threads and requiring the installation of a helicoil?
Cross threaded, over torqued, or under torqued during instillation
Do you have to remove the drivers side axle to remove the transmission from a 1996 Dodge Caravan 3.3 ltr?
Yes, and on some, the right has to be pulled too. You are basically taking the whole front of the car apart. Hope you have a good book, if not go to the Library if you have trouble. And the axle nuts are torqued to about 170ft lbs torque, so you will have to remove them while the vehicle is on the ground, and someone is hold the brake pedal down.
How do you remove the radio in a 2001 dodge caravan sport sport?
Go to the dodge place and ask THEM to remove it
What is the torque spec of a water pump on a 2002 Dodge Durango?
The 2002 Dodge Durango water pump bolt torque specification is 40 pounds. The water pump bolts should be torqued in 20 pound intervals.
