It is in the top left firewall. There are 4 screws to remove, and the blower motor will be attached to the cover of the firewall. Paula
The heater resistor coil is located on the blower motor on the 2006 T300 Kenworth.
To replace the blower motor resistor on a 2010 Kenworth T370, first, disconnect the negative battery cable to ensure safety. Locate the blower motor resistor, typically found near the blower motor under the dashboard on the passenger side. Remove the electrical connector and unscrew the resistor from its mounting position. Install the new resistor by reversing these steps, ensuring the connector is securely attached before reconnecting the battery.
in the heater panel on floorboard plug with three wires have to go through glovebox
This procedure varies between different models. We'd need to know which model you were referring to in order to answer this.
Should be outside of the firewall on the right side of the vehicle.... there'll be a half-cylindrical shaped cover over the compartment... you remove four bolts (should be 13mm for the socket), and the blower motor comes out with the cover, but you have to disconnect the plugs before you take it completely out.
Under the hood, against the firewall, on the passenger side of the vehicle. It's encased in the HVAC compartment, and there's a metal panel you need to remove to access it.
Blower motor fuse is blown. Blower motor resistor burned out. Blower motor switch bad. Blower motor bad.
Blower motor: remove the glove box and you will see the blower motor and blower resistor.
usually the blower motor resistor pkg. located on or near the blower motor
If you are saying the blower motor will not work, then check the fuse. If the fuse is not blown, then it is possibly a defective Blower Motor Resistor Pack, blower motor, or blower motor speed control switch, in that order.If you are saying the blower motor will not work, then check the fuse. If the fuse is not blown, then it is possibly a defective Blower Motor Resistor Pack, blower motor, or blower motor speed control switch, in that order.
It's close to the blower motor.