40 km
The maximum transmission distance for a network using 10Base5 technology, also known as "thicknet," is 500 meters (1,640 feet) per segment. This coaxial cable-based Ethernet standard supports data rates of 10 Mbps and allows for multiple segments to be connected, with up to 2,500 meters total distance when using repeaters. However, the effective distance for practical networking may be less due to the need for network devices and connectors.
A setgement, which is also known as a TCP segment is something that is created based on an application layer of data. An IP datagram is something generated which contains the TCP segment. The segment is located in the payload section.
The measure of how inexpensively a media vehicle communicates with a particular customer segment is often referred to as cost efficiency or cost per impression (CPI). This metric evaluates the cost of reaching a specific audience, allowing marketers to assess the effectiveness of their media spending. By analyzing the cost relative to the reach and engagement of the target segment, businesses can optimize their advertising budgets and enhance their overall marketing strategy. Ultimately, a lower CPI indicates a more cost-effective communication approach.
The segment between the demarcation point and the central office is known as the "last mile."
Departmentalization within an organization effects downward communication. If a company is segmented, executive managers may not be able to communicate to each segment of the organization.
The maximum segment length specified by the 1000BASE-T standard is 100 meters (328 feet) when using Category 5e (Cat 5e) or higher unshielded twisted pair (UTP) cabling. This length includes the total length of the cable run from the switch or router to the endpoint device, accounting for any patch cables used in the installation.
The maximum number of nodes per segment in a network segment typically depends on the specific network technology or protocol being used. For example, Ethernet networks typically have a maximum of 1024 nodes per segment. However, it's important to consult the documentation or specifications of the specific technology being used to determine the exact maximum number of nodes per segment.
185 meters
100 meters
2.5 kilometers
100000mbps
It is true. The book says "The maximum distance a signal can travel and still be interpreted accurately is equal to a segment's maximum length. Beyond this length, data loss is apt to occur."
For use in networks the maximum segment length would be 500 meters
1000 base‑lx
For any Cat 5 cable, the maximum segment length is 100 meters per segment.
1000baseLX is a fiber optic standard for gigabit transmission. It can be up to 5 km using SMF fiber. MMF fiber will allow a maximum segment length of 550 meters.nodes per cable segament
That'd be insects