185 meters
10BASE2, or IEEE 802.3, is an early Ethernet Standard that makes use of industry-standard RG-58 coaxial communications cables connected to BNC T-connectors. 10BASE2 gets its identifier, assigned by the Institute of Electrical and Electronics engineers (IEEE), from the following characteristics: "10" means it has a maximum transmission speed of 10Mbps; "BASE" is shorthand for "Baseband Transmission" or "Baseband Ethernet," meaning that the medium only transmits Ethernet signals; and "2" refers to its maximum network segment length of 185 meters, rounded up to 200 meters.
18,000 feet (5,486.4 meters)
1) It is a distance vector routing protocol. 2) The data portion of a RIP message is encapsulated into a UDP segment.
The k center problem is a mathematical optimization problem where the goal is to select k centers from a set of points in a way that minimizes the maximum distance between each point and its nearest center. This problem is important in various fields such as facility location and network design, where efficient clustering of points is needed.
data link layer should divide frame into segment by ravi from kurnool
The maximum length of a 10Base2 thinwire ethernet cable is 185 ft.
200 meters,
None. A metre is a measure of length or distance while 10base2 is a pure, dimensionless number.
The maximum distance for Ethernet 10Base2, also known as thin coaxial Ethernet, is 185 meters (or approximately 607 feet) per segment. This standard allows for a total network length of up to 2000 meters when using multiple segments connected by repeaters. It operates at a speed of 10 Mbps and uses a BNC connector for connections.
It is true. The book says "The maximum distance a signal can travel and still be interpreted accurately is equal to a segment's maximum length. Beyond this length, data loss is apt to occur."
For use in networks the maximum segment length would be 500 meters
10BASE2, or IEEE 802.3, is an early Ethernet Standard that makes use of industry-standard RG-58 coaxial communications cables connected to BNC T-connectors. 10BASE2 gets its identifier, assigned by the Institute of Electrical and Electronics engineers (IEEE), from the following characteristics: "10" means it has a maximum transmission speed of 10Mbps; "BASE" is shorthand for "Baseband Transmission" or "Baseband Ethernet," meaning that the medium only transmits Ethernet signals; and "2" refers to its maximum network segment length of 185 meters, rounded up to 200 meters.
coax is 200 meter maximum ,if you want more than 200 meter(video transmission) you can even use cat 5 cable with video transmitter and receiver adapters and it will be the cheap and best way. futronicservices@gmail.com
100 meters for a cat-6 segment.
10Base2 is also known as Thin Ethernet
Repeaters are usually used in coaxial based ethernet networks. For this purpose they are used to extend the length of a network segment. For example, in a 10base2 ethernet network the maximum length of a segment is 180 meters. A repeater could join two segments together to increase the length of the network and the number of clients in the network. In today's modern networks you will see neither coaxial networks nor repeaters in a LAN. Repeaters are used for DSL transmissions, but not for LANS.
Depends on the coax type - thinnet coax is 185 meters per segment, thicknet is 500 meters