In order to see the running configuration on a Cisco 2600 router, follow these steps from user executive mode.RouterName> Enable
RouterName# show run
from privileged mode, the command SHOW RUN, will display the configuration in memory
show run
SDRAM
This is an incomplete command. However, this indicates that the running configuration will be saved on the device to a different location.
Router(config)#Copy running-config startup-config
NVRAM is that router component in which start up configuration file is stored.
What is the purpose of using the copy tftp flash command on a router? to back up the current IOS image to a server to restore the IOS image from a server to back up the router configuration to a server to restore the router configuration from flash
The commands that are displayed determine the current operation of the router.
Update the configuration logs
as the commands are entered
copy run start
SDRAM
It depends on model. Some models can save some data without reloading, some can't. Thus you can have partially configured router or not configured at all. But reloading is not going to damage your router.
That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.
This is an incomplete command. However, this indicates that the running configuration will be saved on the device to a different location.
The statup-config is the configuration that is loaded when the router boots or powers up. The runnning-config is the current configuration in the router. It may have been modified since the last boot and so might be different. Having these two provides a nice safety feature. Changes can be made to the running-config and if something badly goes wrong, you can restart the router and get back to the configuration without the changes.
Router(config)#Copy running-config startup-config
I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration
To save the current running configuration you can use the "copy run start" command. Any configurations that are made on a router will not be saved until you use this command and it will save the current running configuration to the local NVRAM. This configuration will then be used on next startup. To back up we can save the configuration to a remote TFTP server with use of the "copy run tftp" command. Always have a back up plan.