0
What else can I help you with?
Why do routers use anding?
ANDing is used by a router, to see if the host which has to be contacted, is on the local network of the router, or a remote network.
How would you obtain the running configuration of a cisco 2600 router in priviledged mode?
In order to see the running configuration on a Cisco 2600 router, follow these steps from user executive mode.RouterName> EnableRouterName# show run
Is the wep key the routOrs password?
No The WEP key is the key used to encrypt the wireless traffic, so people can't sniff the data and see what your doing. No WEP key, no connect to the network. No router password, and you can't log into the router to modify the WEP key.
How does one find out their IP address if they have a Linksys router?
One can reset the IP address with a Linksys router very easily. One must first reset the router, then go into the computer networking settings and reset within the settings.
Why had Len Kleinrock and the other computer scientists gathered to observe the computer and the router?
They were about to see whether information could successfully flow between a computer and router, for the first time in history.
How do you see how much ram is on a cisco router?
The "show version" command.
What command will allow you to see the connections made from your router to remote device?
The command would be show connections.
While configuring a router network technician wants to name a router Which prompt the technician would see when entering hostname command?
Router(config)#
What prompt should a technician see when entering the hostname command for a router?
from the global configuration mode
Which command is used to view the RIP routing protocol settings and configuration?
you can use SHOW IP PROTOCOL you will be able to see all running protocols in your router and its details...
What command allow the user to see the system messages when telnetting into a router?
To view system messages when telnetting, you must enter the terminal monitor command.
A network technician wants to configure an IP address on a router interface by using the ip address 192.168.1.0 255.255.255.0 command Which prompt should the technician see when entering this comman?
router(config-if)#
If your using some one's wifi can they see all of your history?
It depends on how good their router is. If hey hav a goos router, then they will probably be able to see who used their wifi and what they used it for.
If you have adsl router on a network and you dont know its ip how would you do to find it?
If the router supports uPNP then turn on uPNP in windows and see if it detects it as a new device. or, run a command window and type IPCONFIG in the info that comes up... look for the router's address there.
Which router command would you use if you wanted to see the administrative distance of routes?
To view the administrative distance of routes on a Cisco router, you would use the command show ip route. This command displays the routing table, including the administrative distances associated with different routes, which are indicated next to the route entries. You can also use show ip route <protocol> to see specific protocols and their administrative distances.
What is the command used to get into global configuration mode on a cisco router?
On user exec mode type enable. When inside the privilege mode type configure terminal. You will then be sitting into global config after this. Please see below example: Router>enable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#
What command is used to see who is on the system?
Ironically, the command to see who is logged into the system is who. You can also see who is logged on using the wcommand.
