Don’t know
There are three wires supplying power to your home two line wires @ 110 volts each and one nutral.
a usb cable has four wires, two for power and two for communication.
4pairs 8 wires
A link test just confirms that there is voltage on wires 1,2,3, and 6. The active wires in the cable.
There are four wire pairs. White/Blue - Blue, White/Orange - Orange, White/Green - Green, and White/Brown - Brown. Only two pairs are used in Cat5 networks.
With 8 wires, you can store numbers in binary format, where each wire represents a bit. An 8-bit binary number can represent values from 0 to 255 in decimal (2^8 - 1). This means you can store any integer within that range using the 8 wires. If signed integers are considered, the range would be from -128 to 127.
The earliest computers were literally hardwired using logic gates that determined combinations of on/off values over various wires to determine the program. Even once programming moved from hardware to software, binary codes remained the basis of all programming languages.
There is no record of when binary was first used. Given that the ancient Mesopotamian architects were using sexagesimal (base 60) they would have already known about binary encodings. However, it wasn't until India introduced the positional notation system that we use today (the Hindu-Arabic system) that we finally had a method of notating all bases in a common and consistent format. By the time Babbage invented the earliest computers, binary encoding was already a well-established method of digitising data to be processed by a machine.
Code 46 sets when there is a problem with the vehicle anti theft system (VATS), usually caused by broken wires to the ignition lock. you can bypass the resistor in the key (small resistor mounted in black plastic on the key) by measuring the resistance of the key resistor. next find the wires to the ignition lock cylinder (2 small white wires with orange cover) be careful not to confuse with yellow covered air bag wires. unplug white and orange covered wires at bottom of steering column. cut off wires coming from the ignition lock about 3 inches from plug and connect resistors to simulate the key resistance from one white wire to the other. (resistance should be close to key resistance but does not have to be exact) now plug the connector with resistors back into harness and car should start
The different colors of wires used in electrical installations have specific meanings. Red wires are typically used for hot wires, white wires for neutral wires, green wires for ground wires, and black wires for hot wires as well.
A Bus is a set of data/control lines which are basically just a group of wires. e.g if 8085 wants to send 0xFF (255) to an Output device, it would make all the lines of the data bus high, bcoz 0xFF is 11111111 in binary, that is to say all the wires of the bus are 1. (1 means at +5V). -munish
In electrical circuits, white wires are typically used as neutral wires, green wires are used as ground wires, and black wires are commonly used as hot wires.
white wires are neutral. green wires are ground wires.
The wires and that you have the wires
hot wires are black, white wires are ground
a Wii has three wires in all.
A bundle of wires are called a cable.