Well, darling, -6 AN inlet size simply refers to the diameter of the fitting on the end of a hose or tube. The "-6" part corresponds to a specific measurement in inches, so it's basically like saying it's a certain size without actually saying the size. Think of it as a secret code for all the gearheads out there.
your hard disk is accessed at 6 Gigabytes per second, and is a size of 620 Gigabytes.
it is half the inlet mass of the gas
Assess: make a judgment of value, quality, outcomes, results or size
The size can be limited to 6 variables and also can be used for simplifying boolean expressions. Is K-map a msnormer?
You would have to look inside your computer and take the circuit board out and examine it. It should have the information on it.
Inlet line will be bigger then the outlet line. on the contrary on my motorcycle fuel pump, the inlet and outlet are the same size!
Hi, inlet is 25mm and exhaust is 22mm
2.5"
It depends on the vehicle you have. In many cases (but not all) the inlet hose is smaller than the outlet hose.
24".
The thermostat for a 6 cylinder Ford pickup is in the top radiator hose inlet. The hose and inlet need to be removed to install the thermostat..
With No1 cylinder at TDC adjust the following valve clearances, No. 1, inlet and exhaust No. 2, inlet No. 3, exhaust No. 4, inlet No. 5, exhaust Then turn the crankshaft 1 full turn so that No 6 cylinder is at TDC and adjust the following valve clearances, No2. , exhaust No. 3, inlet No. 4, exhaust No. 5, inlet No. 6 inlet and exhaust. Both inlet and exhaust clearances ar 0.4 mm with engine cold. This info is from the original service manual
The general rule is to take the men's size and add two to get the women's shoe size. That would mean that a men's size 6 is a women's size 8.
Usually, people are the same size in both dresses and pants.
inlet 2 to 6 thou. exhaust 6 to 10 thou.
if you mean firing order , it is written on the inlet manifold
The 'inlet' on a muffler refers to the side in which the exhaust gasses from the manifold enter the muffler. The outlet is the side that the gasses exit out to the tail pipe/s.