its like a 555 timer chip. if you know wht that is
Another name for ripple is undulation.
The ideal passband of a receiver should have steep sides and a flat top. However many receivers use stacked filters to create the passband, and consequently the top of the passband sometimes has a ripple on it. This can cause distortion of the received signal.
mod 8 counter mod 8 counter
What are the various Control measures to counter disadvantages of using a computer system?" What are the various Control measures to counter disadvantages of using a computer system?"
In digital circuits, Parallel Counters are series of n flip-flops. It has 2n states. The notion of the word parallel is that, a clock pulse is given at-a-time to all the flip-flops. It may be fed directly. or alternatively, it may be ANDed with some other variable (for example output of previous stage, some other stage etc.).One may have a look at this image :http://www.csbdu.in/virtual/DIGITAL%20MUP/3.2_clip_image015.jpg
It is a counter. A negative input pulse increments counter by one with binary output.
A synchronous counter is not referred to as a ripple counter. They are two different things. The ripple counter uses the output of each stage to trigger the input of the next stage, resulting in propagation delay between stages. The synchronous counter, on the other hand clocks all stages on the same clock edge, making them all change at relatively the same time.
A ripple counter is a counter in which state transitions of one or more flip flops are triggered by the outputs of other flip flops in the circuit. If all flip flops in the counter are triggered by a common clock pulse, then the counter is called a "synchronous counter". a ripple counter is a counter that will ripple through the information sequentialy. .
brief explanation of asynchronous ripple counter
There are five flip-flops in a five-bit ripple counter.
The maximum counting speed of a ripple counter is limited by the propagation delay of the flip-flops used in the counter circuit. As the count propagates through each flip-flop in series, there is a cumulative delay that increases with each stage. This limits the speed at which the counter can reliably count without errors.
Add a circuit to reset it when it hits 10. Yes it will glitch, but ripple counters already glitch.
clock signal divider
The word ripple in ripple counter refers to the fact that the carry ripples from one flipflop to the next, instead of being pre-calculated by logic so that all the flipflops in the counter change state synchronously. Thus the bits in a ripple counter change state asynchronously with the most significant bits changing last. This can produce race conditions and instabilities in logic circuits that are driven by these counters.
16
a mod-10 counter is a basic formula for the male and female combination !
Jimmy Ripple was born on 1909-10-14.