0
What else can I help you with?
What is pretension of bolt?
Bolt pre-tension is also called induced load or clamp load. Induced load in the bolt is the load generated in the bolt at a particular torque value. This induced load value is generally 75% of the proof load value. Parveen Lohera Sr. Manager-QA Deepak Fasteners Limited, INDIA
How can I effectively balance the load of my web applications?
There are several solutions for balancing the load of web applications. There are several Application load balancing softwares available.
Difference between hardware load balancer and software load balancer?
http://serverfault.com/questions/171400/hardware-vs-software-load-balancers-just-a-cost-issue
What is lumped load?
A static load is a constant steady load.Think of a floor, if you stand on it without moving that is a static load. lump load A lumped network is usually a simplification of a distributed network, such as a transmission line. A transmission line has built in resistance, inductance
What command can you use to load the windows desktop?
What command can you use to load the windows desktop?
What is RLS?
It is load resistance RL. It can be any device that can act as a load at the output end. Example : A resistor
What are Ac load lines in an amplifier and how they are drawn?
The dc load resistance is Rc but the AC Load resistance is (RcRl). If a load line is drawn the slope of which is -1(Rc Rl) . Then it is called an AC load line and it is to be used when the transistor is operating as an amplifier.
Wave forms of 3 phase fully controlled rectifier for RL load?
for 3 phase r l load phase control rectifier what is the avg value?
How galvanometer measure the exact voltage with series high resistor?
Assuming galvanometer has zero or negligible internal resistance. If u connect resistor R>>RL(Load resistance) and connect it parallel to RL, it will hardly cause any change in voltage across load resistance. Suppose small current Ig goes through galvanometer. Since galvanometer have zero internal resistance, Voltage across RL = Voltage across R = IgR
What are the effects of Rs and Rl?
The values of Rs and Rl in a circuit impact the current and voltage levels within the circuit. Rs represents the source resistance affecting the input impedance, while Rl represents the load resistance affecting the output impedance. A variation in these values can cause changes in signal attenuation, power dissipation, and overall circuit performance.
What does the rl in Acura rl stand for?
RL stands for Road Luxery
What is the Thevenin theorem?
The current flowing through the load terminals Rl connected across any two terminals A & B of a linear, bilateral, active network is given by Voc/Rth + RL where VOC is the open circuit voltage across the terminals A & B & RL is the internal resistance of the network as viewed back into the open circuited network from AB deactivating all the independent sources.
Did rl stine have sisters?
RL sine had no Sisters
In eudragit rl 100 what does rl stand for?
hfkjf
What is the meaning of rl-eligibility in urdu?
rl-eligibility
When was Acura RL created?
Acura RL was created in 1996.
When was Mancunians RL created?
Mancunians RL was created in 2009.
