Then the component will not work or will be unreliable.
A CD/DVD Rom drive is connected by either connecting an IDE or SATA data and power cable to the drive, the other end of the data cable is connected the a slot on the motherboard and the power cable already comes out of the PSU.
a usb cable is a cable that allows the computer to communicate with the object u are connecting it to. For example there is a computer powered fan which is connected to a computer using an usb cable
3core*400mm2 xlpe cable
Power cable is a thick cable connecting your computer to an electrical wall outlet. It can also be a thin wire connecting your modem or other device to a rectangular [ usually ] power supply to your electrical power bar or wall outlet. Data cables are much thinner, used mainly internally, and can be many wires attached together horizontally to form a wide ribbon of wires. However, a data cable can also be a much thicker cable connecting your modem, router, printer etc. to your computer.
If you disconnect the power cord to the hard drive, when you turn the computer back on, the hard drive will not be operational. Additionally, if you leave the IDE (or SATA) cable connected when the power cable is disconnected, the system will take longer to POST because it will try to identify the device connected, but it will not be able to. If it is the only hard drive you have in your system, the computer won't boot up because your operating system is on the hard drive.
A CD/DVD Rom drive is connected by either connecting an IDE or SATA data and power cable to the drive, the other end of the data cable is connected the a slot on the motherboard and the power cable already comes out of the PSU.
There is no load connected!
There are two cables connected to the floppy drive; Power cable - 4 pins, Data cable - 34 pins.
Your fuse box is linked by a power source. The power source cable goes directly to the battery. Check the power source cable to make sure it is connected properly.
Open the case and see if the power AND the ribbon cable are both plugged in. If the drive's read light is staying on constantly the cable is connected backward. Also, make sure the floppy is properly set-up in the BIOS.
This problem could be as a result of a loose power or data cable. The solution is to open the computer case and check that all cables are properly connected.
The current flows through the cable of the plug, to whatever wants to be turned on.
The starter cable for the 99 Blazer is connected to the battery cable below the battery tray. A plastic box encloses a fuse that connects that battery cable to the starter cable and the chassis power.
nothing seems to be broken. the cable is not connected to the drive bracket
You can charge the odys z22 by connecting the provided charging cable to a power source, such as a computer's USB port or a wall adapter. Make sure the charging cable is securely connected to the device and power source. The device should start charging once connected.
get a new cable for it or make sure it is in properly !
The purpose of the black cable in this electrical circuit is to carry the electric current from the power source to the connected devices or components in the circuit.