answersLogoWhite

0

"debug ip rip" is the correct answer. Use to display information on selected RIP events. This command has many keywords that allow you to specify a variety of RIP events. You can set the level of severity for the events you want displayed; specify the desired descriptive term or a corresponding number (0-7). You can set the verbosity of the messages you want displayed: low, medium, high. Example host1#debug ip rip events Use the no version to cancel the display of any information on the designated variable.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What is the command on a Cisco router that will display all the routes the router knows?

show ip route


Which command will display the router's configuration register setting?

show version


Which command will display statistics for all interfaces configured on a router?

show ip int brief


What command will display all connected ospfv2 routers?

To display all connected OSPFv2 routers, use the command show ip ospf neighbor in the router's command-line interface. This command provides a list of OSPF neighbors, including their state, router ID, and interface information. It helps in verifying OSPF adjacencies and troubleshooting OSPF connectivity issues.


Which cli command display the static routes in the routing table?

conf terminal Router#show ip route


What command can you execute from user mode to display the current IOS version and feature set running on a router that your consoled into?

To display the current IOS version and feature set running on a router, you can execute the command show version from user mode. This command provides detailed information about the IOS version, the router's hardware, memory, and feature set. Alternatively, show version | include Version can be used to filter the output specifically for the IOS version.


What router prompt can you use the router rip command?

On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.


When does the banner display for cisco router?

whenever you log into your cisco router....


How to use router rip command?

use of routerrip command


Which command will display the chap authentication process as it occurs between two routers in the network?

To display the CHAP (Challenge Handshake Authentication Protocol) authentication process between two routers, you can use the command debug chap authentication in the privileged EXEC mode on a Cisco router. This command will provide real-time output of the CHAP negotiation process, showing the challenges and responses exchanged during the authentication. Be cautious when using debug commands in a production environment, as they can generate a lot of output and potentially impact performance.


Which command delet the router?

routedelet


What does the router command router bgp 65003 mean?

It's cheese time