Because pencil has graphite lead, which is a good conductor of electricity. Hence to avoid the shock pencils are avoided.
Because a pencil's "lead" is a material that will donduct electricity and therefore a pencil line inadvertently drawn on the motherboard will cause a short circuit,
the processor and hard drive. you wouldn't want a small shock to destroy your components do you?
Get a new one. The problem maybe that its old or something is not working right
1. Temperature: The Computer uses electricity or electronic circuits component which generate a lot of heat, these causes discomforte to it's users, to aviod this computer enviroment should be well airconditonal and enough fans provided and installed to cool the office.
First, try holding down the power button on the side for 10 seconds. If that doesn't work, take a piece of lead from a mechanical pencil (or something else like that) and look on the bottom. Inside the little silver thing that you use to put it on a tripod, there's a tiny black button. Press that with the lead and hold it. It should be working after that.
Never keep your Notebook Computer in working state, powered on or with battery installed while cleaning. Also never spray any cleaning liquid nearby openings on Notebook Computer. Never clean parts of Notebook Computer by tight hands.
The desk and computer.
Yes. You should wear one whenever you work inside a computer.
the processor and hard drive. you wouldn't want a small shock to destroy your components do you?
it should be on the computer, go to control panel, then mouse then settings and change it.
Make sure your sound card is properly connected inside your computer to the motherboard. Make sure the driver is working properly. check your sound card and your wiring.
buy a new one.
open it
You should always where a ground strip when working on the internals of a computer. You should always unplug the computer from everything before working on it and ground yourself to the computers metal case. This will equalize the static electricity between you and the mother board and her components.
You need to find a power source first. Such as, a windmill, etc.. Then you need to connect a generator to the power source. Then after the generator is working, you can connect wires from the generator, to the computer. After it is all connected, the computer(s) should be up and running perfectly! :) However, if you put a computer inside, there is no need to do all that work. A computer will work without a power source if it is inside.
Computer engineer. If you are considering working on video games I recommend working for Trendy Entertainment, they have jobs opening. :)
get a sound card for the computer
100F/38C Should not exceed 100F/38C