First, IPv4 is limited in the number of addresses. When it was developed, 4 billion addresses seemed more than sufficient, but that was before the days of ubiquitous personal computers, smart phones, and even the World Wide Web. Now there are millions of web servers on the internet, and billions of people. Every device needs a unique address (this isn't strictly accurate - firewalls, NAT, proxy servers and connection sharing helps some). It is estimated that IP address for the Internet will "run out" within a year.
IPv6 is a 128-bit address scheme, allowing for 3,400,000,000,000,000,000,000,000,000,000,000,000,000 addresses. That's 6,500,000,000,000,000,000,000,000 addresses for every square meter on Earth.
Next, IPv4 provides no facility for good security. Some techniques have been used to layer security protocols on top of TCP, but IP spoofing, man-in-the-middle attacks, and other hacks still leave network connections vulnerable.
There are other reasons as well, but I'll let someone else address those.
Both 1 and 2. Also, RIPng (for IPv6).Both 1 and 2. Also, RIPng (for IPv6).Both 1 and 2. Also, RIPng (for IPv6).Both 1 and 2. Also, RIPng (for IPv6).
In IPv4, the loopback address is 127.0.0.1. In IPv6 it is ::1.
1. Describe the main features that differentiate IPv6 from IPv4
Short answer - yes.You need to be running Service Pack 1 at a minimum.Service Pack 2 has an even more complete IPv6 stack.To enable IPv6 on XP, open a command prompt window and type:C:\> ipv6 /?Did you then see this result?:C:\> ipv6 /?Could not access IPv6 protocol stack - the stack is not installed.To install, please use 'ipv6 install'.If you did get the above result, simply type:C:\> ipv6 installIt will take a few seconds, and then your Windows XP system will be fully IPv6 enabled.
The loop back address for IPv6 is 0:0:0:0:0:0:0:1 or it is abbreviated as ::1
The IPv6 equivalent of the IPv4 loopback address 127.0.0.1 is ::1. This address is used to refer to the local host in IPv6, similar to how 127.0.0.1 functions in IPv4. The "::" notation represents a shorthand for consecutive blocks of zeros in IPv6 addressing.
1. A new DNS was created to allow a domain name to be associated with a 128-bit IPv6 address.
the primary reason for resource accountability is to
To verify TCP IPv6 protocols, you can ping the loopback address, which is ::1. This address is used to test the local network stack of the device itself. Additionally, you can ping a well-known IPv6 address, such as 2001:4860:4860::8888, which is a Google Public DNS server, to check connectivity over IPv6.
IP is properly installed on the host.
127.0.0.1 in IPv4 or ::1 in IPv6
In IPv6, the same result can be achieved by sending a packet to the link-local all nodes multicast group at address ff02::1, which is analogous to IPv4 multicast to address 224.0.0.1.