Traces.
When you look carefully at a motherboard, you see many fine lines on both the top and the bottom of the board's surface. These lines, sometimes called TRACES, are circuits or paths that enable data, instructions, and power to move from component to component on the board.
The layer that can route data on different paths by creating virtual circuits is the Transport Layer, specifically in protocols like TCP (Transmission Control Protocol). It establishes a connection-oriented communication channel and manages data flow, ensuring reliable transmission. Additionally, some techniques at the Network Layer, such as MPLS (Multiprotocol Label Switching), can also create virtual circuits for routing data efficiently across networks.
traces
closed circuits. hope this helps :D
An ungated D latch in digital circuits is a memory element that stores a single bit of information. It has two inputs: a data input (D) and a control input (enable). When the enable input is high, the D latch stores the value of the data input. When the enable input is low, the stored value remains unchanged. This allows the D latch to hold and remember a bit of information until it is updated.
At least two paths. Current will divide between them according to their relative impedances.
The width of the data path in bits
Data enable, signals that bus lines are being used to transfer data
the Pulmonary and systemic are the two circuits
Then the network won't work, unless there are alternate paths where the data can pass.Then the network won't work, unless there are alternate paths where the data can pass.Then the network won't work, unless there are alternate paths where the data can pass.Then the network won't work, unless there are alternate paths where the data can pass.
to enable data to be set
a switch
that is called a perfect circuit