If the device you are powering requires 7 amps of power, then no. You will need to find a replacement cord with 7 amps. Check the power input requirements of the device to find out.
Yes. The cord only transmits the power. Whatever that goes in is what comes out.
Yes, you can use a 10 amp 125 volt power cord on your computer with a 6 amp 125 volt input. The power cord's amp rating represents the maximum current it can handle, so it is suitable for your computer's lower amperage requirement. Just ensure the voltage matches to avoid any potential damage.
Yes, no problem at all going to a larger ampacity of wire. Larger size wire yes, smaller size wire no.
Yes the rated voltage is a maximum. A 250 v cord might be slightly thicker than one for 125 v. <<>> The voltage rating of an electrical extension cord is the insulation factor of the cord. These cords come in two insulation ratings, 300 volts and 600 volts. If the voltage rating is within the parameters of the cord maximums then it is safe to use it on that voltage. The amperage of the cord is based on the wire size of the cord's conductor. The rating of 10 amps will fall within the #14 cord size. Remember the longer the cord the larger the wire size should be to prevent voltage drop at the connected load end.
You need to define what you mean by 2.0 and 1.6.
You tell yourself the 125 volt receptacle is a 120 volt receptacle. They're the same thing.
No. At 125 volts, the same 15 amp current results in 10 times as much power. Ohm's Law states that amps x volts = power.
It indicates that the power cord is rated to handle a maximum current of 7 amps and a voltage of 125 volts. This information is important to ensure that the power cord is compatible with the device it is connected to and can safely carry the required electrical load.
No, the 220 v and 110 v systems are designed to use a different pin layout for the plugs and sockets, to avoid possibly dangerous cross-connections. The two voltages can not be mixed and equipment for one system cannot be used on the other without a transformer.
Yes.
According to this , yes it will work http/forums.lenovo.com/t5/IdeaPad-S-series-Netbooks/Voltage-Supply-Range-of-the-Power-Adaptor-and-the-cable/td-p/181204 <<>>> The above answer was taken from forums, not the most reliable source of information. No, a 125 volt adapter can not be used in a 220 volt outlet.
Yes, a 110 volt device can be plugged into a 125 volt receptacle. The voltage rating on the receptacle is only there as the highest voltage supply that the manufacturer recommends their equipment be connected to.