0
How can you tell which side of a hard drives data cable connects to pin 1 on the drive?
These PC cables have a notch or key on one side of plug and can only be inserted in one orientation in connector socket. If the notch is missing, you may also look for a small arrow mark on pin 1 of the cable plug. Other marking is that the ribbon or flat cable some times will have the first wire in a different color compared to rest of the cable.
- Ron Patton
What else can I help you with?
What data cable attatches to the optical drive?
A Molex Connector connects to optical drives and hard drives.
What is a 7-pin cable that connects to an external drive?
A 7-pin cable that connects to an external drive is typically a SATA (Serial Advanced Technology Attachment) cable. This cable is used to transfer data between the external drive and a computer, providing a fast and efficient connection for hard drives and solid-state drives. The 7 pins facilitate both data transmission and power supply for the connected device.
Which type of hard drive cable connects drives in a daisy chain series and requires manual termination at each end of the daisy chain to prevent data corruption?
The SCSI cable.
What does a floppy drive cable do?
A floppy drive cable connects a floppy disk drive to a computer's motherboard, allowing data transfer between the two. It typically consists of a flat ribbon design with multiple connectors that can accommodate one or two drives. The cable transmits data signals and power to the floppy drive, enabling it to read from and write to floppy disks. While floppy drives are largely obsolete, these cables were essential for their operation in earlier computing systems.
In a system that uses a CD drive were the audio wire connects?
There is a data cable,and a power cable that connect the drive to your PC. Everything is done with the data cable, there is no audio or video wires.
Explain how the two available drives on FDD data cable are distinguished?
Floppy data cable is 34 pin flat cable having two connectors for floppy drive. The floppy drive connected at the end connector is A: and the another connector disk is B:..
When two drives are connected to the same data cable connected to an IDE channel how does BIOS know which drive controls the controls the channel?
Cable Select or by the jumpers put on the hard drive
A parallel ATA connector can accommodate one data cable for tow drives?
A parallel ATA connector can use one data cable for two drives.
How can you use double hard discs in your computer?
The second drive is mounted in any convenient spot above or below the first, and the flat ribbon cable going to the first drive usually has a second connector part way down the cable that can CAREFULLY plug into the second drive. It is sometimes labeled 'Slave', and only fits one way. Connect a spare power connector to the drive, and set the little jumper in the back of the drive to either CS (cable select) or Slave. These instructions are for older PATA drives that use a wide, flat, ribbon cable. For newer SATA drives, it mounts the same, and the power is the same, but there is a separate thin data cable that connects the second drive straight to the motherboard SATA connector. The computer should recognize the new drive once it's powered up, and will assign it an available drive letter.
What happens when two drives are connected to the same data cable connected to an IDE channel. How does BIOS know which drive controls the channel's?
There are jumpers on the drives that differentiate the master from the slave. If the jumpers aren't set correctly, the BIOS will not recognize them. In addition, some IDE ribbon cables are also labled Drive 0 (or Master) and Drive 1 (or Slave). If the jumpers are set correct, but the drives are plugged into the ribbon cable incorrectly, the computer will not recognize the drives.
What is a floppy drive data cable?
a cable for connecting a floppy drive to the computer motherboard.
What two cables connect to the hard disk?
There are two cables that connect to the floppy drive in a desktop computer.There is a four pin power cableThere is a ribbon cable that has a part twisted end (the twisted end connects to the floppy drive).
