There are several ways to convert a 240 volt input to a 1.5 volt output.
If the 240 volt input is alternating current (AC), a simple transformer can reduce the 240 volts to 1.5 volts (AC). A properly configured resistor or impedance coil in series with the input and output would also do the job but a tansformer also serves to isolate the output from the input offering greater protection for the 1.5 volt device. You If 1.5 volts direct current (DC) is required, a rectifier circuit is needed after the 1.5 volt AC output. If the source is 240 volts (DC), A resistance circuit in series can reduce the output voltage. You can also use electronic circuitry to chop of the 1.5 volts.
To convert 7620 volts to 240 volts, you would need to use a transformer. The transformer would step-down the voltage from 7620 volts to 240 volts. The ratio of the turns on the transformer primary and secondary windings determines the voltage transformation.
No, it is not recommended to convert a Yamaha Clavinova from 120 volts to 240 volts. This could damage the instrument and void any warranty it may have. It is best to purchase a Yamaha Clavinova that is already rated for 240 volts if needed.
only way to convert from 3 phase to 240 would be to change the electric motor on the compressor
To convert a fraction to percent multiply by 100 % 36/240 × 100% = 15% → 36 is 15% of 240.
To convert watts to amps, use the formula: Amps = Watts / Volts. In this case, 3000 watts divided by 240 volts equals 12.5 amps. Therefore, 3000 watts at 240 volts is equal to 12.5 amps.
If it is AC then you don't need a formula, you just need a transformer.
To answer this question a current value needs to be given. 125000 is the product of amps times volts. I = W/E = 521 amps. So to bring 240 volts up to 125 KVA you need the circuit load to draw 521 amps.
It is not recommended to convert the voltage of electrical appliances as it can be dangerous and may cause damage to the appliance or pose a safety hazard. It's best to purchase an electric fan that is designed to operate at 240 volts if needed.
voltage is the PUSH on electrons seriously 120 volts is the difference of 240...Simply said 240 volts is 2 times as strong as 120 volts.
Amperes when kva is shown. The formula is, Amps = kva x 1000/1.73 x volts.
240 volts maximum.
The standard voltage conversion ratio from 240 volts to 120 volts is 2:1.