To replace the ETC (Electronic Throttle Control) sensor in a Mazda RX-8, first disconnect the negative battery terminal for safety. Locate the sensor on the throttle body, then remove the wiring harness connector and unscrew the sensor from its mounting. Replace it with the new sensor, reattach the connector, and reconnect the battery. Finally, ensure the throttle system is calibrated properly, if necessary, before starting the vehicle.
how do i remove the starter motor Mazda rx8
The 2011 version of the Mazda RX8 was the last model produced by Mazda. Models of the Mazda RX8 are still available for purchase and can be found online.
WE CAN GET MAZDA RX8 IN GTA SAN ANDREAS By installing rx8 mod
you'd have to get the tire size. It's on the tire itself.
check your coils for spark.if there ok replace the plugs and wires
wher can you find the chassis number of mazda rx8
Rx8, but not by too much.
2004-6 front in exhaust manifold top one, rear in cat on side.
how good were they Nazda RX8 2004
Nope.
Well fiery thing you should do is get you mazes rx8 back because it worked in it
No, the RX8 does not have camshafts, therefore it does not require a timing belt.