answersLogoWhite

0

Personally, I would avoid placing the mainframe near vents such as these. The best operating temperature is one that is rather stable and doesn't fluctuate too much - excess heat causes electronics to work much harder and wear out sooner.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Heating company near me?

Dynamic Heating & Cooling in Hamilton, ON, is your go-to expert for all HVAC needs.


During a storm what is the shock wave called that comes from the heating and cooling of air near lightning?

thunder


Where is the cooling fan switch on a 92 dodge caravan?

The cooling fans are controlled by the engine computer. It watches the coolant temp sensor, which is near the thermostat, to decide when to run the fans. Yhe computer acuates a realy to turn the fans on.


In order to heat a room evenly should heating vents be placed near the floor or near the ceiling of the room?

It would be better to place the heating vent near the floor because the heat will travel up and down, so that way the room would be heated evenly. If you place it near the ceiling, the heat would not heat the floor that well, since the heating vent sucks back in the heat


Where is wet bulb temperature measured in the heating mode?

Wet bulb temperature is measured as part of the air temperature when a heater is running. It is measured at the return air grille (near the return air duct) or at the supply air grille (near the supply air duct). It is important to measure wet bulb temperature in the heating mode because it indicates the amount of moisture in the air and helps to determine the amount of cooling or heating that is needed. Wet bulb temperature is measured at the return air grille.Wet bulb temperature is measured at the supply air grille.Measuring wet bulb temperature in the heating mode helps to determine the amount of cooling or heating needed.


The heating and cooling fan only works in the high position. Do I need to replace the fan or is their a sub electrical system connected?

Try the HVAC, it is Heating, cooling, AC, regulator. located near the blower motor. it controls the amount of voltage going to the motor, the highest setting by pass the restictors that is why it only works on high., Might locate one at a junk yard. good luck,


Why is the cooling coil of the refrigerator placed near the top of its cabinet?

It isn't always, but the advantage of putting it there is that heat (hot air) rises. You'ld rather not have that hot air heating up the body of the refrigerator.


Where is the cooling fan sensor for a 1998 Chrysler town and country?

The computer uses the coolant temp sensor which is located near where the upper radiator hose hooks to the engine.


Why are nuclear reactors usually near water?

Cooling. The water is available for the cooling system.


In order to heat a room should heating vents be placed near the floor or near the ceiling of the room?

Heating vents should be located near the floor since hot air rises. If the heating vents are located near the ceiling the heat would stay there and not warm the room.


Where can I find a HVAC dealer near Terre Haute, Indiana?

Make sure to find a reputable contractor to handle your heating and cooling needs. here is the yellow page search link: http://terre_haute-in.yellowusa.com/Air_Conditioning_Contractors.html


Is it okay if school has a near computer shop why or why not?

In their store windows so children would know the business is a safe place to get help.