Its fairly self explanatory, put the input IN then check the output at the OUTPUT.
There is no answer to this question.
A fault can be resistive in nature, and the amount of resistance in the fault is unpredictable. It is unusual for a fault to be inductive or capacitive, so a typical method is to determine the impedance to the fault, and compare only the inductive part of this to the inductive part of the line impedance.
The six point technique of fault finding used in mechanical maintenance is called the hexagonal method. It also sometimes called the six sigma and is a process of quality control.
what are the possible fault in colour tv transmitter and receiver?how we can overcome this fault?
Unit of fault level is KA. Kilo amps
Robber Barons
Robber Barons
little advantage
Unit substitution in fault finding with electrics involves replacing a suspected faulty component with a known good one to determine if the issue lies within that component. This method helps isolate the fault by eliminating variables and allows for a systematic approach to diagnosing electrical issues. By substituting units, technicians can quickly identify whether the problem is due to the specific component or if the fault lies elsewhere in the system. This technique is commonly used in troubleshooting electrical circuits and devices.
One such word is criticize.
1. Test the system, ie make measurements or collect other evidence 2. Analyse the readings 3. Locate fault based on analysis (step 2) 4. Determine the original cause of the fault. (ie find a method to prevent recurrence) 5. Repair the fault (bearing in mind step 4) 6. Retest the system