You would use a set of wire strippers made for stranded wire and proper size. If the strippers are made for stranded and solid make sure you use the size identifications for stranded not solid!
Appliances cords are made of stranded wire because it is more flexible and less likely to break than solid wire. The multiple strands of wire in a stranded conductor also make it more resistant to fatigue and bending, which is important for a cord that may be moved and adjusted frequently.
no
Wire can be fabricated in two different forms. Solid wire refers to a single wire, while stranded wire is a wire which is made up of more than one single solid wire twisted together. A stranded wire is much more flexible, and less subject to breaking from flexing than a stranded wire of the same size.
It would of course depend on the specific application. Current tends to travel on the surface of a conductor and a stranded conductor has more surface area and thus offers less resistance to the current. Stranded wire also bends a bit easier than the corresponding size solid wire.
Solid wire generally offers better electrical conductivity and heat dissipation compared to stranded wire. It is also easier to terminate and can provide a more stable connection in certain applications.
Yes, wire rope consists of multiple strands of wire twisted together to form a larger, stronger cable. Stranded wire refers to individual wires twisted or braided together to form a single strand. Wire rope is typically used for heavy-duty applications that require extra strength and durability, while stranded wire is more commonly used in smaller-scale applications.
Another name that can be used for a multi-strand wire is a cable.
For life safety systems, it is typically recommended to use stranded wire. Stranded wire is more flexible and less prone to breakage due to movement and vibrations, making it a more reliable choice for critical applications where durability is important.
Overcoat: Individual strands of tin copper stranded together & then covered with a tin coating. Topcoat: Bare (untinned) copper wire, stranded, then coated with pure tin.
Either one can be used. Electricians prefer to use a solid wire and use the screw terminals rather that the pressure terminals. An eyelet can be formed with solid wire where as using stranded wire takes a bit more preparation to use. The stranded wire has to be wound tighter at the termination end. This is so that when the stranded wire is tightened under the screw terminal the wire does not splay into individual strands some of which do not get under the terminal screw. With some of the strands not tightened under the screw, this is the same as using a smaller size wire. The breaker feeding the receptacle is matched to a specific wire size. The now smaller wire size has a breaker greater than the ampacity of the wire. This could lead to overheating of the wire under full load and eventually cause a breakdown of the insulation. Once the insulation has broken down, the breaker will trip due to a short circuit. This wire will have to be replaced. This could involve opening the wall board to remove the burnt wiring should this happen.Most residential wiring is done with solid copper wire. In industrial applications, stranded THHN wire is used because many wires are run through conduits from service boxes and many different colors and gauges can be run to different locations. I personally would not use stranded in a residential application.
high frequencies utilize the skin effect, running on the exterior of the conductor, with low frequencies utilizing the core of the conductor. Stranded wire has more skin area and would enhance higher frequencies, while solid wire would enhance lower frequencies. stranded is more flexible