0
Daisy chaining is when you tie up a rope a certain way for storage so that you will not damage the rope when it is not in use. You can make one by making a loop at one end of a rope, pulling a little bit of rope the the loop to form another loop, pull some rope through that rope to make another loop, and so on until the end when you pull the end of the rope completely through the last loop. If you do it right, you will be able to un-daisy chain the rope in one pull. The whole method is very convenient.
What else can I help you with?
Difference between daisy chaining and polling?
suca
What is the potential problem with daisy chaining hubs on a?
loss of signal and data
Can you daisy chain USB hubs?
Yes. USB can support 127 devices per port which allows for daisy chaining.
What is the potencial problem with daisy-chaining hubs on a 10base-t network?
Pangit ka
What is a potential problem with daisy-chaining hubs on a 10base-T network?
exceeding the maximum network lenght
Which of the following is a potential problem with daisy-chaining hubs on a 10BASE-T network?
Exceeding the maximum network length
What ports allows daisy chaining of multiple devices but does not require any CPU cycles to move data?
parallel
Can you connect multiple devices to a single USB port by daisy chaining them you must use a hub instead?
You should use a hub. Sometimes you can daisy chain, but you can get unpredictable results.
What are Potential problem with daisy-chaining hubs on a 10BASE-T network?
exceeding the maximum network length network + guide to networks Chapter 5 Review Question 6
Which devices can be daisy chained?
Often times, external monitors/extra monitors are daisy-chained. Some computers will have a setup where, say, three cables go directly out of the computer into three seperate monitors, but sometimes one cable goes out from the computer to the monitor, which is linked up (daisy chain) to other monitors.
What is Daisy Chains in logical topology?
Daisy chaining is a term used to denote that one system is directly connected to the next system without any intervening devices. It is usually reserved for linear bus topologies in a network, but can be applied to other things as well, such as SCSI disk hard drives which can be chained together.
Could a relay race be used as a good model for a parallel or series circuit?
A relay race could be a good model of a series circuit. In any circuit, current flow is the daisy-chaining of electrons from atom to atom.
