0
What else can I help you with?
Can Mov used in 8085 for immediate data transfer?
No, not at all this instruction MOV can not be used for immediate data transfer. You will need to use command MVI Rd, 8 Bit Data for immediate data transfer.
What is mov instruction in 8086?
The MOV instruction in the 8086 microprocessor is used to transfer data from one location to another. It can move data between registers, from memory to registers, or from registers to memory. The syntax typically follows the format MOV destination, source, where the destination receives the data from the source. This instruction does not affect the flags in the status register.
What are the function of MOVE instruction?
The MOVE instruction is used in assembly language programming to transfer data from one location to another. It copies the contents of a source operand (such as a register or memory location) to a destination operand. This instruction does not modify the source data; it simply creates a duplicate in the specified destination. MOVE is fundamental for data manipulation and management within a program's execution.
Which group of instruction do not effect the flag?
(a) Arithmetic operations (b) Logic operations (c) Data transfer operations (d) Branch operations
What is used to transfer data and instruction by using spoken language?
Speech recognition technology is used to transfer data and instructions by converting spoken language into text or commands that can be understood by computers or devices. This technology allows users to interact with devices through voice commands or dictation.
What type of data transfer is carried out using a USB port?
The type of data transfer that is carried out using a USB port are varied. Some of the types of data transfer include bulk data transfer, isochronous data transfer and interrupt data transfer among others.
What is the different between MOV and MVI in 8085?
In the 8085 microprocessor, the MOV instruction copies data between two registers, or between a register and memory. The MVI instruction differs only in that the source data is contained in the byte immediately following the opcode byte.
What is the difference between access time and the transfer rate for a hard drive?
access time is the amount of time required to deliver item from memory to processor. While, transfer rate is the speed with which data, instruction, and information transfer to and from a device. Transfer rate for storage are stated in KBs, MBps and GBps..etc
What is the actual speed of data transfer on a network?
less than the data transfer rate
How data transfer operation is done in 8085 micro processor?
Data transfer in the 8085 microprocessor can be done with the help of several instructions like the MOV,MVI,OUT and IN . Lets say, we want to move the contents of a register R1 to register R2, then we could use the instruction MOV R2,R1 ; and so on...
Why all the 16 address lines are not act as a data lines in 8085 microprocessor?
the 8085 microprocessor is a 8-bit microprocessor and these are bidirectional but the address lines are unidirectional.these address lines are used to address the location of the instruction in memory .these data lines are used to transfer data between processor and peripheral devices. when the address of the instruction will be recognized by the address lines the data will be send to the processor therefore the 16 address lines are not act as a data lines in 8085
What is a transfer order?
It's an instruction from one bank to another - to transfer funds between accounts.
