answersLogoWhite

0

Use compresed air to blow out dust. Clean the rollers with a cotton swab dipped in a very small amount of liquid soap. The sticky side of Duct Tape works well to clean the mouse ball.

You can purchase a cleaning kit for the mouse, trackball, and keyboard.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What is the best way to clean a trackball so the mouse responds faster?

Remove the cap with the hole below the mouse, remove the ball and clean it, and clean the rolling cylinders that you will find inside the hole were the ball came from.


The best way to clean a roller-ballmouse is?

I use a babywipe to clean the ball, and then (and I've never found this to cause problems) I use a straightened paperclip to pick off the little layer of gunk on the little wheels. This usually comes off in little lumps which I can then shake out of the mouse. Don't forget to clean your mousemat also.


What is the best way to clean a wireless mouse?

Use compressed air and blow it out.


How do you clean English springer ears?

dapen a cotton ball with vinegar and water mixture is the best way. Then clean it up with a dry cotton ball.


What is the best way to clean a paint roller tray after using it for a project?

The best way to clean a paint roller tray after using it for a project is to first scrape off excess paint with a putty knife, then wash it with warm, soapy water. Rinse thoroughly and allow it to dry completely before storing it for future use.


Which image best represent kinetic energy?

A roller coaster going down the highest hill on it's coarse


How do you adjust sensitivity on ball mouse?

If you are looking for the control panel options, then Rtrahan is correct. However, if your question is regarding why the mouse is no longer moving as easily as it used to, then you might take a look at the rollers inside the mouse and see how much dust, hair, and other junk is impacted on them. A ball mouse has a very bad habit of picking up just about anything that can float by in the room. Therefore, it is best to clean off the rollers every month or two. If you find that there is a lot of stuff on the rollers, then gently scrape at it with your fingernail and when you have it knocked loose, pull it out of the mouse. Once you have done this to both rollers, your mouse should move normally once again.


What is the best pet mouse?

the best mouse to keep for a pet is female fancy mouse


How to paint with a roller effectively and efficiently?

To paint with a roller effectively and efficiently, start by choosing the right roller cover for your surface. Use a high-quality paint and load the roller evenly. Begin by rolling in a "W" pattern to evenly distribute the paint, then go back over the area in a vertical direction for a smooth finish. Work in small sections and avoid overloading the roller to prevent drips. Clean the roller thoroughly after use for best results.


What is best exercise ball exercise?

The dvd, "Core Body Workout with Exercise Ball and Foam Roller" by Jean Goulet has extensive ball exercises, including aerobics, stretching and strengthening. It includes exercises for the entire body but emphasizes the glutes, abdomens and low back.


What is the best wireless mouse of 2012?

According to the complexmag site, the best mouse of 2012 was the Logitech Performance Mouse MX. However, the best mouse is subjective and people will have different opinions.


Can you use meths or white spirit to clean a printer roller instead ff alcohol?

Using meths (methylated spirits) or white spirit to clean a printer roller is not recommended, as these solvents can leave residues or cause damage to the roller material. Isopropyl alcohol is preferred because it evaporates quickly and does not leave harmful residues. Always refer to the printer manufacturer’s guidelines for the best cleaning practices to ensure optimal performance and longevity of your printer.