You need to be a bit more specific here. What is the speaker in? Which end are you talking about: the speaker end or the amplifier end? What are you trying to hook up? Phil
The speaker sound will turn off and the sound will go into your earphones.
you plug them in
To plug in a microphone to a speaker, you will need to connect the microphone's cable to the input jack on the speaker. Make sure the microphone is turned on and adjust the volume levels on both the microphone and the speaker to achieve the desired sound output.
Assuming there is 8 wires in existing Renault wiring iso speaker plug at back of radio, the two outer wires at each end of plug are for left rear and right rear speakers, tap into these wires i.e. strip the insulation back a couple of inches from the plug and join new speaker wires onto the stripped wires. If only 4 wires in existing Renault wiring iso speaker plug then buy iso speaker plug from auto factor and join existing Renault wiring on speaker plug onto new cable and join new speaker cables (the ones you are fitting) onto the outside wires at each end of the new iso plug.
plug into apple device....
only plug in the microphone plug into your computer while still plugging in the speakers.
It's the place where you plug in the speaker wire. Speaker wire runs to the speaker allowing the electrical signal to operate the speaker or headphones. The speaker wires are fitted with a special kind of plug that will fit the speaker jack. Many computer manufacturers position the speaker jack in unique places. A few put the speaker jacks on the front of the computer, some put them on the back, laptops generally put the speaker jack on the side.
When in doubt, put it in the green socket. It might also be marked as "speaker" or "headphones." You can try the headset plug in front if there is one there. Otherwise, try the green or "speaker" socket in the back if there is one there.
the alpine 7914 is pre-amp only you need a amp
An iHome is a speaker that you can plug your ipod into and sometimes includes a clock.
Into a USB outlet of your computer.
You can simply plug the audio cord from the speaker into the audo out port on your sound card. This allwos you to hear the sounds through the speaker.