0
On a 1994 Chevrolet 3500 with a 454 TBI (Throttle Body Injection) engine, the Intake Air Temperature (IAT) sensor is typically located in the intake manifold or the air intake duct, just before the throttle body. It may be found mounted directly in the air cleaner assembly or in the ductwork leading to the throttle body. If you are having difficulty locating it, consult the vehicle's service manual for a detailed diagram and specific location.
What else can I help you with?
How do you change a fuel pump on 1994 Chev 3500?
Remove the fuel tank or remove the bed.
Where are the sensor for airbag 2012 chev cruze?
where are they located
Where is the speed sensor for a 1994 chev 4x4?
It is screewed into the rear of the transfur case.
Where is camshaft position sensor located on 1995 chev truck?
There is no cam sensor on the 1995 year engine. GM. did not use a cam sensor on that year.
Why don't my 1994 Chev 3500 brake lights work?
it is broken Check the fuse, check the bulbs, check the brake light switch, in that order.
Where is the cam shaft position sensor on a 2004 chev optra?
The sensor is located directly above the crankshaft pulley. The camshaft sensor also connects with the crankshaft position sensor.
Where is the camshaft position sensor located on a 1997 Chev S10 pickup with a 4.3 liter V6?
On the 97 s series trucks with the hvs, The camshaft sensor is located inside of the distributor.
Which O2 sensor is bank 1 sensor 3 location for a 1997 chev S-10 V-6 4WD?
That would be the O2 sensor located after the catalytic converter.
Where is the abs wheel sensor on the chev calavier 2004?
where is the abs wheel sensor on a 2004 chev calavier thanks
Where is the speed sensor located on a 1996 chev blazer and how do you replace it?
IT'S ON THE TAILSHAFT EXTENTION HOUSING OF THE TRANSFER CASE.
Where is the map sensor located on a 98 chev silverado pickup?
The map sensor is plugged into the intake manifold. It will behind the throttle body on the passenger side of the vehicle.
Where is the slave cylinder on 1995 chev silverado 3500?
the slave cylinder is either located just above the starter or its an internel one part of the throwout bearing.
