0
What else can I help you with?
Which command or set of commands will stop an RIP routing process?
To stop an RIP routing process on a Cisco router, you can use the command no router rip in global configuration mode. This command removes the RIP configuration and stops the RIP routing process from running. Alternatively, you can use shutdown within the RIP routing configuration mode to disable RIP without removing its configuration.
What are cisco device configuration commands?
cisco configuration command guide
How do you know the configuration of your OS?
The command uname -a
Which command can be used at the command line to start the printer configuration program?
Ubuntu: system-config-printer brings up a GUI printer configuration
What AT command use for reset modem configuration?
sdddsfsdfdf
What is accomplished by the command copy tftp running-config?
This command will allow you to copy a configuration from a TFTP server to the running configuration of a Cisco device. When you issue the command you will be prompted for further details about the TFTP server. The new configuration will replace the active one (or running configuration) and make any necessary changes.
What command prompt do you type for system start configuration?
F9
What command can display tcpip configuration and refresh the ip address?
On Windows the command is IPCONFIG. That displays the configuration, though IPCONFIG /ALL displays everything. To do a DHCPREFRESH, type IPCONFIG /RENEW.
What command displays the configuration stored in NVRAM?
wr or copy running-config startup config
How do you save running configurations on router?
To save the running configuration on a router, you typically use the command copy running-config startup-config in the privileged EXEC mode. This command copies the current configuration stored in RAM (running-config) to NVRAM (startup-config), ensuring that the configuration is retained after a reboot. Alternatively, you can use the shorthand command write memory. Always confirm the save by checking the startup configuration with the show startup-config command.
Which command can be used at the command line to start the Network Configuration program?
To start the Network Configuration program from the command line, you can use the command nmtui for a text-based interface or nm-connection-editor for a graphical interface, depending on your system configuration. Alternatively, on some systems, you might use network-manager or nmcli for command-line management of network connections. Make sure to run these commands with appropriate permissions if required.
What is network Configuration?
The system network configuration refers to assigning a particular IP address by a network configuration window. The configuration window is usually invoked by selecting the network configuration sub menu from the setup command.
