0
What else can I help you with?
How can configure VLAN on a switch port?
To configure a VLAN on a switch port, first access the switch's command-line interface (CLI) via console or SSH. Enter configuration mode by typing configure terminal, then select the specific interface using interface [type][number] (e.g., interface FastEthernet0/1). Assign the VLAN to the port with the command switchport access vlan [VLAN_ID], and if needed, set the port to access mode using switchport mode access. Finally, save the configuration with write memory or copy running-config startup-config.
Is write a FORTRAN command?
Yes. The FORTRAN write command output's data to a file.
What the tab is used to configure the write caching and safe removal settings for a device?
The Policies tab.
How do you write the command to stop a horse?
Whoa.
Write the syntax for find command in dos?
For most DOS commands you can write COMMAND /? and you will be presented with a list of possible choises. eks. FIND /? Regards.
Is bloging social networking?
blogging and social networking are a simular thing but blogging is more a page all about a certain thing that people write about e.g. wikepedia
What is the rewrite command for isam file i dibol?
WRITE
What does the word escriban mean?
It is a command. It means "write".
What is the plural command in spanish that means write to me?
escriban
Which command will delete all data from a table and will not write to the rollback segment?
Truncate since it is DDL command
How do you get the IPA of a computer from the command prompt?
In command prompt write "ipconfig/all" command and then press [enter]. And see the IPv4 Address section in the commend prompt.
What is check disk command?
it checks for errors or defects on your hard drive and tells the computer not to write there anymore
