0
The rubber in a rubber band is poor quality and will disintegrate in a short time. However I did just that in a CD changer in my component stereo system. I wanted to make sure the player, which had been stored for a couple of years, still worked. The drive belt had become too loose to work the mechanism, so I found a rubber band the right size and put it on. It works fine, and since I cleaned the lens at the same time it now tracks fine, again, as well. I should emphasize that this is a temporary fix until I can locate a source for a quality drive belt, as the rubber band will not last long and the rubber in a rubber band gets sticky and could damage the player if I leave it for a long time. Best to get a good replacement belt if you can find a source for one.
What else can I help you with?
How do you replace a drive belt in a 2003 Toyota Corolla?
how to replace drive belt 2003 Toyota matrix
Replace a vauxhall corsa drive belt?
how to change the drive belt
How do you replace sickle drive belt case 8370?
how do you change belt
How do you replace a drive belt on a 38yard machine lawn mower?
How do you replace a mower deck belt on a stx38 hydro
How do you replace drive belt on cub cadet LTX 1040?
how do you change drive belt on a ltx 1040 cub cadet
How do you reduce slip on belt drive?
tighten belt or replace it if it is glazed on contact surfaces
How do you loosen and or tighten the drive belt on a 1990 Ford Thunderbird?
You can't, the belt is called a serpentene belt, you have to replace the belt.
How do you replace the belt on the drive shaft pulley on a White LT 12 Lawn Mower?
You need to remove the underdeck to replace the belt.
How do you replace drive belt on cub cadet RZT 50?
You can replace the drive belt on cub cadet RZT 50 by first making sure that the engine of the vehicle is turned off. Then you can pop open the hood and remove the belt.
Why belt slippage coming in v belt drive?
Adjusted too loose, belt is glazed over and worn out, replace it.
How do you replace traction drive belt?
To replace a traction drive belt, first, ensure the equipment is turned off and disconnected from any power source. Remove any covers or guards obstructing access to the belt, then carefully loosen the tensioner to relieve tension on the belt. Slide the old belt off the pulleys and replace it with the new belt, ensuring it is properly aligned. Finally, re-tension the belt, replace any covers, and reconnect the power source.
El falcon how to replace drive belt?
how do i take a belt tensioner arm off a el falcon
