0
What else can I help you with?
When replacing the AC evaporator in a 1996 Jeep Grand Cherokee are there any other components that need to be changed?
the receiver dryer and the orifice tube My 95 had a styrofoam liner in the evaporator box that had crumbled with age and plugged up not only the drain tube but the vent tubes. I would replace that as well as long as you have the dash apart. It is not a must but Personally I would consider replacing the heater core since you have to remove it to get the evaporator out anyway.
On an '88 VW Jetta fixing AC system was this system built without a receiver?
The receiver dryer is the can looking thing next to the evaporator.
Where is the freon valve for a 2000 Mercury Cougar located?
HeyJolly==It is by the receiver dryer which is that big shinny can looking thing by the evaporator. GoodluckJoe
Do you have to replace the receiver dryer on a 2000 Honda Accord if you open the system to replace the valve cores?
Good idea to.
Where is the location of the dryer receiver for 1994 Mazda 929?
The 1994 Mazda 929 dryer receiver is located on the firewall in the engine compartment. The dryer receiver will be on the passenger side of the firewall.
Where is the receiver dryer 2002 pathfinder?
The Receiver Dryer is on the driver's side of the condensor, behind the front bumper. It's the long, silver cannister.
Where is the low pressure port located on a 2000 Chevy blazer?
on the evaporator / dryer
Where do you add R 134A to a 2000 F250 pickup?
On the passenger side there is a port on the receiver/dryer. The receiver/dryer is located next to the pluming box under the hood.
Can you replace a gas dryer with an electrical dryer?
Yes
Where is the liquid line located on a filter dryer?
The liquid line on a filter dryer is typically located at the inlet side of the device. It carries the refrigerant in its liquid state from the condenser to the evaporator. The filter dryer's primary function is to remove moisture and contaminants from the refrigerant before it enters the evaporator, ensuring efficient system operation and longevity.
Can you use r-134a instead of r-22 Refrigerant?
10 years ago they kept telling us that replacing R12 a/c system with 134 gas was not recommended because will destroy the compressor and so on, I have retrofitted all my vehicles to 134A with no negative consequences ,so I believe it can be done Just have to evacuate the system totally and remove the oil from the condenser,evaporator and receiver dryer(Filter) and add the recommended oil for 134A gas .
How do you convert r12 to 134?
The manual will say change all the flexible lines and O rings. The truth is that you will need to remove the compressor and receiver tank. Drain all the oil from the compressor, replace the receiver/dryer. Insert new 134 compatible oil. Replace all disturbed O rings. Charge with 134A . Should work
