A lead acid cell has an off charge/no load voltage of 2.2 volts, so that 12 cells in series will have a voltage of 26.4 volts. When you float this across a charging supply, standard practice is to increase the voltage to 2.3 volts per cell, so that the total voltage becomes 27.6 volts.
Airplanes normally have a 27.6 volt DC system, and larger aircraft also have a 115 volt 400 Hz system. Also, rare these days, possibly a 115 volt wild frequency system.
Note that the so called 12 volt system in a car is actually 13.8 volts.
Higher acid / lower pH in limes
A multimeter is an instrument that can be used to measure cell voltage in a lead-acid battery. By setting the multimeter to the appropriate voltage range, you can connect the probes to the battery terminals to obtain a direct reading of the voltage of the battery or individual cells. This helps assess the state of charge and overall health of the battery.
AnswerAccording to WikiPedia (http:/en.wikipedia.org/wiki/Rechargeable_battery), the nominal cell voltage of a Lead Acid wet-cell battery is 2.1 volts, this implies there are 6 cells in a 12 volt Lead Acid wet-cell battery.
For lead-acid chemistry, as in a car battery, think 13.6 volts DC.
It depends on what the 6 cells are, but the battery voltage is just 6 times the cell voltage. In a car battery (lead-acid cells) - 12V In a dry-battery (zinc-carbon cells) - 9V
Leaking from where on the battery, the caps? If so the charging system may be over charging the battery and causing the acid to boil out. Could be a voltage regulator problem.
Each cell of a modern lead-acid battery should have an average voltage of about 2 volts but, depending on the cell's condition and state of charge, the exact voltage at any time may be somewhere in a range from about 1.8 volts (when it is almost fully discharged) and 2.25 volts when it is fully charged.
The voltage of a battery is determined by the chemistry inside it ... zinc/carbon, nickel-metal-hydride, lead-acid, lithium ion, etc. But nobody's expected to be able to look at it, or smell it, and know the voltage. If the voltage isn't printed on it, then you have to pull out the old voltmeter and measure it.
No, you should not charge a 6-volt 4.5Ah sealed lead acid battery with a 12-volt charger, as the voltage is too high and could damage the battery. Sealed lead acid batteries need to be charged at their specified voltage, typically around 7.2 to 7.4 volts for a 6-volt battery. Using a charger with the correct voltage and current rating is essential for safe and effective charging. Always select a charger designed for the specific voltage and chemistry of your battery.
Carrying acid on a airplane is illegal and i don't recommended it.
They produce hydrogen during charge and discharge.
2