0
What else can I help you with?
Why wont my Mitsubishi galant won't start?
I have a 2010 mitsubishi galant i have to push the gas to start the car what's wrong
How do you deactivate the alarm system of your Mitsubishi galant 1999?
To deactivate the alarm system on a Mitsubishi Galant 1999, place the key into the ignition and turn it slightly. Leave the key in this position for 10 minutes and then start the car.
Can you drive a mitsubishi galant without the front ecu?
No, the car will not start.
Why wont your Mitsubishi galant start?
If your Mitsubishi Galant won't start, it could be due to several reasons such as a dead battery, faulty starter motor, or issues with the ignition system. Check the battery connections and ensure the battery is charged. Additionally, inspect the starter and ignition components for any signs of failure. If these components seem fine, the problem might lie in the fuel system or engine sensors.
Why would a 1994 Mitsubishi Galant not start?
Maby because it dosent have any gas in it, or because the battery is dead.
How do you set the clock on a 2003 Mitsubishi eclipse?
Haha, I was just struggling with this in my Mitsubishi Galant... If it's like mine you just have to *hold* the minutes or hours button and it will start progressing.Hope this'll help!
How do you adjust the air and fuel mixture on Mitsubishi Galant 2000 mikuni carburetor?
Start at 1 1/2 turns from seat and adjust for best idle
Why does your Mitsubishi Galant die when it gets warm and will not start till it cools down?
Check your ignition module. When it gets warm or hot it loses spark if its faulty.
What is wrong when a 1999 Mitsubishi Galant 6 cylinder will start but dies before you can put it in gear?
I just had the same problem on my 2001 Galant ES. I took it to get repaired and I was told that it was a displaced or off-centered camshaft. Cost me $380 parts and labor.
How much water do you put into a Mitsubishi galant radiator?
What?! Until full! Start the vhicle, run for 10 inutes to enable the thermostat to open and the coolant to flow. Add the proper mix of coolant to fill the radiator to the bottom of the neck. The system will be sufficienty full
How do you reset the oil change light on an Mitsubishi galant?
To reset the oil change light on a Mitsubishi Galant, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off and then start the engine to ensure the light is reset. If the light remains on, repeat the process.
Can you put a remote start on a standard 1994 S10 pickup?
No, standard transmission vehicles cannot have a remote start system.
