If the solute isn't very soluble, the solution can be saturated and still have very little solute in it, so it would be dilute.
The bulk of the water can often be removed by shaking or "washing" the organic layer with saturated aqueous sodium chloride. The salt water works to pull the water from the organic layer to the water layer. This is because the concentrated salt solution wants to become more dilute and because salts have a stronger attraction to water than to organic solvents. Note: sometimes a saturated aqueous solution of sodium chloride is called brine.
The solute normally doesn't dissolve and sinks to the bottom of the container. However, some saturated solutions can become super-saturated for a given temperature and pressure, by altering the conditions without allowing solute to precipitate.
Adding solvent will make a solution more diluted. Think of it this way. Take water (solvent) and dissolve salt into it (solute). In order to dilute or increase the ratio of solvent to solute, you would add more water.
Well, friend, to dilute 1 liter of a copper chloride solution from 100,000 ppm to 1 ppm, you'll need to add quite a bit of water. You see, for every liter of the original solution, you'll need to add 99 liters of water. This will help bring the concentration down to that lovely 1 ppm you're aiming for. Just remember to mix it all up gently, like you're painting a beautiful sky.
Yes, a saturated solution of chloride can still dissolve Epsom salts (magnesium sulfate) because the two compounds have different chemical compositions and solubilities. The chloride ions in the solution do not interfere with the solubility of Epsom salts.
sex
Yes, just remove some of the solvent. If you want to see this for yourself, mix a little salt and water together. Then leave it stand so most of the water evaporates. You have saturated a dilute solution.
A saturated solution contains as much pof the dissolved material as possible. A dilute solution is almost the opposite, it has only a trace of the dissolved material and the solution could contain much more.
A solution can be dilute and saturated if there is a small amount of solute relative to the amount of solvent, making it dilute, but all of the solvent has already dissolved the maximum amount of solute possible at that temperature, making it saturated. This can happen when the solute has low solubility in the solvent or if the temperature decreases after the solution has been prepared.
a saturated solution is a solution that cannot dissolve any more substances a concentrated solution is a solution that has a lot of a specific substance in it
No, the dilute solutions of highly water soluble compounds are unsaturatd as solution of NaCl but dilute solution of AgCl or BaSO4 are saturated because they are very little soluble in water.
Adding water to a saturated solution will dilute the concentration of the solute, causing some of it to come out of solution. The solution will no longer be saturated because the solute can no longer all remain dissolved in the water.
A concentrated solution has a high amount of solute dissolved in a solvent, while a dilute solution has a low amount of solute dissolved in a solvent. The concentration of a solution is usually expressed in terms of mass or volume of solute per unit volume of solvent.
We define Osmosis as the passage of water from a dilute solution via a membrane which is semi permeable to a more concentrate solution. It means that Semi permeable membrane is a very thin layer of material which allows some molecule to pass through them and prevent some molecule from pass through them. These molecules are decided by the type of solution. Generally, the membrane only allows movement of H2O molecules. So, if on one side is a saturated solution of something while on the other side is a dilute solution, the movement of molecules will be from both the directions but net result will be from saturated to dilute solution.
A dilute solution is one that has a low concentration of solute compared to the solvent. This means that there is a smaller amount of solute dissolved in the solvent, resulting in a less saturated or weaker solution.
they both have to mix with water
You think probable to a dilute, unsaturated solution.