The Saturn 4 cylinder engines were available in 2 styles, the single overhead cam and the dual overhead cam. In both engine types, the camshafts were always in the head, just under the top cover of the engine. If you remove the top cover (where you install the sparkplugs) you will see the camshaft(s).
The front axle torque specs of a 1999 Saturn is 41 ft lbs. It is the axle shaft support bracket to engine bolts.?æ
The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.
It is located in the front of the engine on the cylinder head. It's located on the passenger side of the vehicle.
2.2 litre it's the pully in front of engine at the end of crank shaft.
Where is the crank shaft located on a 1999 Pontiac Bonneville? I have bought the part. Just can't find where it goes.
Thermostat is located on the passenger side of the engine. If you look where the two hoses are going from the radiator and the resiviour this part comes out and the thermostat is located underneath.
Where is cam shaft position sensor on a 4.3 engine. Located?
CPS is located above the starter on the back side of the engine held in with a 10mm bolts.
The CPS is located on the front of the engine attached to the harmonic balancer on the front of the crankshaft.
The 1999 Chevrolet Alamo crank shaft position sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crank position sensor.
The crank sensor is behind the starter. Remover the starter at the back of the engine and you will see the sensor
On the bottom right of the engine.