In a 1994 Saturn SL1, the windshield wiper motor is located under the hood, mounted on the driver's side of the vehicle. It is positioned near the base of the windshield, attached to the wiper linkage. To access it, you may need to remove the plastic cover that protects the wiper assembly. Once the cover is off, the motor can be easily identified and accessed for repairs or replacement.
Remove the windshield wiper arm from the windshield wiper motor. Remove the wiring harness. Remove the retaining nut. Reverse the process to install the new windshield wiper motor.
The windshield wiper motor is located just below the windshield wiper blades and is covered by a black panel.
Make sure that the nuts holding the wiper arms are sufficiently tight to ensure that they move when the shaft turns thus moving the wiper arm.
right under the cover that the wiper blades mount to
The windshield wiper motor on a 1994 Geo Metro is located under the hood, typically near the base of the windshield on the driver's side. It is mounted to the firewall and connected to the wiper linkage that operates the wipers. To access it, you may need to remove the wiper arms and possibly the plastic cover that protects the area.
Under the vin plate. fold the windshield forward.
http://www.autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/19/a5/ca/0900823d8019a5ca.jsp Copy and paste into your browser.
To replace the windshield wiper motor on a 1994 E320, begin by disconnecting the vehicle's battery to ensure safety. Remove the wiper arms by loosening the retaining nuts and lifting them off the splines. Next, access the wiper motor by removing the interior panel and any necessary trim pieces to expose the motor. Disconnect the electrical connector and bolts securing the motor, then remove the old motor and install the new one by reversing the process. Reattach the wiper arms and reconnect the battery before testing the new motor.
Weak battery or alternator output.
In a 1994 Ram pickup, the wiper motor is typically located on the passenger side of the firewall, underneath the dashboard. It is mounted near the base of the windshield and connected to the wiper linkage. Accessing it may require removing the plastic trim or cover in that area.
The 1994 Jeep Grand Cherokee takes 20" replacement windshield wiper blades on both sides front and a 10" or 11" wiper on the rear.
You need to remove the wiper motor and linkage assembly. Then disconnect the motor from the linkage, and turn on the wipers, to see if the motor is running or not. Then when you have the linkage out, manaully move back and forth to see if its binding or not. Usually a bad motor. Unfortunately, MB seems to have many problems with the wiper blade motors.