0
To turn off the VCS (Vehicle Stability Control) light on a 2007 Toyota Highlander, locate the VSC button on the dashboard, usually near the gear shift or on the instrument panel. Press and hold the button for a few seconds until the indicator light turns off. If the light remains on, it may indicate an underlying issue with the vehicle's stability control system, and a diagnostic check may be necessary.
What else can I help you with?
Why does the maintrequired light flash 6 timeswhen you turn SUV on on your Toyota highlander?
It's telling you to change the oil.
How does vsc light turn off on 2005 highlander?
How does vsc light turn off on 2005 highlander?
What is the turn signal light bulb part number for a 2007 Toyota Highlander and how do you replace the turn signal bulb?
2007 Toyota Highlander turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
How do you turn off the maintenance required light on Toyota highlander 6 cylinder 2004?
Read the owners manual. It has step-by-step instructions.
What causes the check engine light to come on in your 2007 Toyota Highlander Hybrid?
Any fault that affects emissions will turn the light on. You need to have it checked for codes to know possible causes.Any fault that affects emissions will turn the light on. You need to have it checked for codes to know possible causes.
How do you reset tire pressure light on Toyota 2007 highlander?
There is a reset button underneath the dash just right of the hood latch. Pressing and holding will turn it off. Then let go of button and press it again and tire pressure light will flash 3 times and then reset.
Where can you find a fuse box schematic for a 2007 Toyota Highlander?
Remove the fuse box cover and turn it over. The positions of all the fuses and their identification is molded into the back of the cover.
How do you turn engines light Toyota Yaris?
i have engine light staying on in my 2005 toyota yaris how do i turn off the light
Maintenance required light Toyota 2007 highlander?
Turn ignition to 'ACC' and press the odometer button until the display reads actual mileage... not Trip A or B. Turn ignition off. Hold in the same button you used in step 1. While holding the button in, turn ignition to 'ON'. The 'Maint Reqd' light should blink and go out. Done! If you wish to confirm, this info should be in your owner's manual.
How do you reset the Maintenance required light in a 2005 Toyota Highlander?
Turn key on. Set odometer to odo not trip a or b. Turn key off. Press and hold trip setter. With trip setter still held turn key on, continue to hold trip setter for 5 seconds. Reset Main req light after an oil change. **Nope, doesn't work, just tried it on 09 highlander.
How do you turn off the general maintenance light on a 2005 Toyota highlander?
1. Turn the ignition key to the 'Lock" position with the odometer (total mileage) reading showing. 2. Turn the ignition key to the "On" position while holding down the trip meter reset knob/button. Hold down the knob for at least 5 seconds. The odometer will indicate "000000" and the light will go off. If the system fails to reset, the light will continue flashing. Note: This procedure is in the 2005 Highlander owners manual under the section entitled "Operation of instruments and Controls (Section 1-6) and is not limited to the Highlander but may apply to other Toyota models and model years as well.
What causes a loud squeaking noise whenever you turn ignition on your 05 Toyota Highlander on?
probably the fan belt
