check the fuses
the computer and the ignition module give power to the injectors.
Are you getting power to the system?
To check if injectors are getting power, you can use a multimeter to measure voltage at the injector connector while the engine is cranking. Set the multimeter to the DC voltage setting and probe the connector terminals; you should see a voltage reading (typically around 12 volts) if the injectors are receiving power. Additionally, you can listen for a clicking sound from the injectors while an assistant cranks the engine, indicating they are being activated. If there is no voltage or clicking, further investigation into the wiring, fuses, or engine control unit may be necessary.
Check the camshaft sensor. If the sensor is bad or not getting power, then the engine will not fire and the injector will not get a signal.
it will spit and sputter or miss or just not have no power at all very sluggish
== ==
Injectors that have a resistor in the power supply are called
Replace you ignition module, It controls both spark and power to the injectors. You can have spark but the module may be bad and not giving power to the injectors and the vehicle will not run.
try checking the amount of pressure your injectors is getting under the hood i believe they should be getting 40 pounds if they are getting incorrect pressure it will affect ur power
Not much info to go on but, do a fuel pressure test to se if you are getting the proper fuel pressure to the injectors. Year, make, model and engine size would help us help you.
i have a 92 mercury carpi i have fuel i have spark but will not start i do not have power to my injectors not sure where to start on how to get power please help
no gas no power