Yes, a 440 Volt 50 Hz device can typically operate on a 380 Volt 50 Hz supply, but it may not perform optimally and could be at risk of under-voltage conditions. Devices designed for higher voltages might require a specific voltage to function correctly, and running them at a lower voltage can lead to reduced efficiency or potential damage. It's essential to check the manufacturer's specifications and recommendations to ensure safe operation.
Answer for UK and countries running a 50 Hz supply service.The voltage potential of 380 volts is not common to North America.It will probably be difficult to tap into the plug to get the voltage.If you have a three phase 380 volt supply from a source then you can obtain a single phase voltage of 220 volts from it. 220/380 is a wye voltage connection. 380 divided by 1.73 will give you 220 volts. L1 - N = 220V, L2 - N =220V, L3 - N = 220V. L1 - L2 = 380, L2 - L3=380, L3 - L1 = 380.
20 HP Three phase 360 volt what is the amps
It shouldn't damage the equipment. But it will probably not work properly.
No, the voltage gap between the two voltages is too large.
depends on the amperage. 14 AWG for 15 amps, 12 AWG for 20 amps, 8 AWG for 50 amps.
no it will start to smell after a few min.
Answer for UK and countries running a 50 Hz supply service.The voltage potential of 380 volts is not common to North America.It will probably be difficult to tap into the plug to get the voltage.If you have a three phase 380 volt supply from a source then you can obtain a single phase voltage of 220 volts from it. 220/380 is a wye voltage connection. 380 divided by 1.73 will give you 220 volts. L1 - N = 220V, L2 - N =220V, L3 - N = 220V. L1 - L2 = 380, L2 - L3=380, L3 - L1 = 380.
no only a ktm 50 engine will work good for a 3 stroke 380
20 HP Three phase 360 volt what is the amps
50% = 0.5 0.5 x 760 = 380
Yes, a 380 volt motor can typically be run on a 415 volt Australian system, as the voltage difference is within acceptable limits for most industrial motors. However, it's important to verify that the motor is designed to handle the higher voltage, as prolonged operation at a higher voltage can lead to overheating and reduced lifespan. Additionally, ensure proper installation and adherence to local electrical codes for safety and compliance.
No, the RPMs of the motor will be wrong and the compressor will be damaged.
Yes, a 220 Volt 50 Hz appliance should work on a 240 Volt 50 Hz supply. The appliance would receive slightly more voltage, but typically a small variation like this should be within the appliance's acceptable range. Just ensure that the appliance is rated for the higher voltage to prevent any potential damage.
No they are not equal680nf = 0.68uf
Yes
380/500 = 38/50 = 19/25
No because the pump motor will run too fast and the lifetime of the fridge will be severely reduced.