A current cannot exist without voltage but voltage can exist without current.Simple example is battery. A battery has votlage even though it is not connected elsewhere.
Keeps the current in the conductor. Without the insulation on a conductor the current can and will leave the intended path in the electrical circuit if it comes in contact with some other conductive path if there is a difference of potential.
a circuit with no resistance or zero resistance can be considered as open circuit in which the current is zero. without resistance the circuit just becomes open ()
A complete electrical circuit occurs when it is possible for electrical current to flow through the electrical devices in it.
An electric circuit connected so that current passes through each circuit element in turn without branching.
Closed circuit means circuit is complete without any break in between and current is flowing if there is any source.
Yes. This is the build up of charge. The difference in charge, aka the potential difference, is the driving force that causes current to flow. The third law of thermodynamics is in action when the circuit is completed and the current flows between two point as a result of the potential difference between those two points. (p.s. I am an American girl)
Voltage is potential energy and can exist in a open circuit.
Keeps the current in the conductor. Without the insulation on a conductor the current can and will leave the intended path in the electrical circuit if it comes in contact with some other conductive path if there is a difference of potential.
When the switch is open, the voltmeter measures the potential difference (voltage) across the terminals of the circuit components or power source it is connected to. This measurement indicates the voltage available in the circuit without any current flowing, allowing for the assessment of the electrical potential that could drive current if the circuit were closed. The reading reflects the circuit's voltage characteristics under open-circuit conditions.
Ammeters are connected in series with the circuit to measure the current flowing through it, ensuring that all the current passes through the meter. In contrast, voltmeters are connected in parallel across the component or section of the circuit where the voltage is to be measured, allowing them to measure the potential difference without significantly altering the circuit's behavior. This arrangement ensures accurate readings without disrupting the flow of current.
YEs if Merlin is at the one end of the line and harry potter at the other, then it is possible.
Your question is a perfect, shining example of a case in which a drawing is virtually indispensable. With a drawing, I would have some clue regarding the nature of "the current", "the circuit", and "the metal" of which you speak. Without a drawing, about the best I can tell you is that the current, expressed in Amperes, in any series circuit is numerically equal to the quotient of the potential difference between the ends of the circuit, expressed in volts, divided by the sum of the resistances of every dissipative element in the circuit, expressed in ohms.
A volt is a unit of electromotive force or potential difference between two points in an electrical circuit. It represents the push or pressure that moves electric charges through a circuit. It is used to measure the difference in electric potential energy between two points in a circuit.
To raise the temperature difference without changing the current, you can increase the resistance in the circuit. This can be done by adding additional resistors in series, using a material with higher resistance, or by adjusting the configuration of the circuit to increase the overall resistance. By increasing the resistance, the same current will produce a greater voltage drop across the resistors, resulting in a higher temperature difference.
A: NO voltage is a potential that theoretically can exits without any current flow
Voltmeters must be connected in parallel with the component or section of the circuit where the voltage is to be measured. This parallel connection allows the voltmeter to measure the potential difference across the component without significantly affecting the circuit's operation. It is important to ensure that the voltmeter has a high internal resistance to minimize the current flowing through it and avoid altering the circuit behavior.
In a short-circuit condition, the terminal potential is 0 volts. This is because the circuit has been bypassed directly from positive to negative without passing through any load, so there is no voltage drop across any components.