In a Resister u can find totally FORE colored rings.The First three rings used to calculate the value of the resister while the fourth ring indicates the tolerance.
Let i say an example how to calculate the value of a resister.
there are 10 colors commonly using in resister.Each color indicates a value.
let me say it.
Black-0
Brown-1
Red-2
Orange-3
Yellow-4
Green-5
Blue-6
Violet-7
Grey-8
White-9
A residter has
1.Yellow
2.Violet
3.Brown
4.Gold
So yellow value is 4,Violet value is 7,Brown value is 1
So 47(Yellow)(Violet)*10^1(Brown) =470 Ohm and gold indicates +/- 5% tolerance. That is min value of that resistor is 446.5 Ohh and max value of that resistor is493.5 Ohm.
Note: Most of the resistor have Four rings only. But aso there are resistors available with 5 rings
To determine the value of Stabilizing resistor Rs = Vs/Is = If(Rct +2Rl)/Is Where, Rs = resistance value of the stabilizing resistor Vs = voltage at which the relay will operate Is = current flowing through the stabilizing resitor and the relay If = maximum secondary fault current magnitude Rct = internal resistance of the current transformer Rl = resistance of attached wire leads
okay, where's the "given waveform"?
in a digital meter you get a digital value of your measurement. but in analog meter you have to check the position of the pin along the scale and find out the value.
The peak of a waveform that is purely sinusoidal (no DC offset) will be RMS * sqrt(2). This is the peak to neutral value. If you are looking for peak to peak, multiply by 2.
The unit step signal is a Power signal. Since when we find the power it comes to 1/2 (i.e finite value). And when we find its energy, we got INFINITY. If a signal has energy as infinity and power as a finite non-zero value, then it is a power signal, not an energy signal.
Blower moto resitor
R = E/IThe resitance of the resitor is (2/6) = 1/3rd ohm.
the RMS value of ac voltage is equivalent in power to the exact same DC voltage. This will cause the same amount of heating in a resistor.
The resitor is probably burnt out on the high mode
You can use ohm's law, which says I=E/R. You should find how many volts that the power supply is, then find out the current flow through the wires. if the current flow is not what it should be, then your resistor is not working properly. Therefore the resitor would be the problem.
Top, drivers side fender
How do you find the value in exponets
Find the value of the fraction.Find the value of the fraction.Find the value of the fraction.Find the value of the fraction.
to find the value of an expression, you need to
To determine the value of Stabilizing resistor Rs = Vs/Is = If(Rct +2Rl)/Is Where, Rs = resistance value of the stabilizing resistor Vs = voltage at which the relay will operate Is = current flowing through the stabilizing resitor and the relay If = maximum secondary fault current magnitude Rct = internal resistance of the current transformer Rl = resistance of attached wire leads
I find the value of six squared by multiplying 6 by itself.I got my answer by explaining in words how I find the value of 6 squared.
Normally you would find the critical value when given the p value and the test statistic.